Failure of the Right Wing and Engine Scan Lighting

TASK 33-49-00-810-801-A
Failure of the Right Wing and Engine Scan Lighting

1. Possible Causes

LT-WING & ENG SCAN, R [4LX]
wiring
SW EXT LT/WING (2LX)
C/B-LIGHTING/EXT LT/WING/AND ENG SCAN/R [1LX]

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 33-49-00-710-001	Operational Test of the Wing and Engine Scan Lights
ASM 334901
AIPC 334908
AMM 33-49-11-000-001	Removal of the Wing and Engine Scan Light
AMM 33-49-11-400-001	Installation of the Wing and Engine Scan Light

3. Fault Confirmation
Subtask 33-49-00-710-050-A

A. Test
Do the operational test of the wing and engine scan lighting AMM 33-49-00-710-001.

4. Fault Isolation
Subtask 33-49-00-810-050-A

A. If, during the operational test, when you set the EXT LT/WING switch (2LX) to ON, the right wing and engine scan light (4LX) does not operate correctly:

NOTE: For the GLS LEDs technology, if there are three or more LEDs that do not come on, Airbus does not make sure that sufficient lighting or a minimum of the lighting as given by the sealed beam lights will come on.

do a check of the circuit breaker (1LX) status.

(1) If the circuit breaker is closed:

do a check for 115VAC at the switch (2LX) pin 2A.

(a) If there is 115VAC:

replace the LT-WING & ENG SCAN, R [4LX] AMM 33-49-11-000-001 and AMM 33-49-11-400-001.

1 If the fault continues:

do a check for a ground signal at the right wing and engine scan light (4LX).

a If there is no ground signal:

repair the wiring from the right wing and engine scan light (4LX) to the ground terminal ASM 334901.

b If there is a ground signal:

do a check and repair the wiring from the switch (2LX) pin 2A to the pin A/A of the right wing and engine scan light (4LX) ASM 334901.

(b) If there is no 115VAC:

replace the SW EXT LT/WING (2LX) AIPC 334908.

1 If the fault continues:

do a check for 115VAC at pin 3 of the circuit breaker (1LX).

a If there is no 115VAC:

replace the C/B-LIGHTING/EXT LT/WING/AND ENG SCAN/R [1LX] .

b If there is 115VAC:

repair the wiring from the circuit breaker (1LX) to the pin 1A of the switch (2LX).

Subtask 33-49-00-710-051-A

B. Do the test given in Para. 3.

[Rev.8 from Aug 2018] 2026.04.04 04:32:02 UTC