Landing Lights - Landing Light does not retract

TASK 33-42-00-810-803-A
Landing Lights - Landing Light does not retract

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 33-42-00-710-001	Operational Test of the Landing Lights
ASM 334201
AMM 33-42-11-000-001	Removal of the Landing Light
AMM 33-42-11-400-003	Installation of the Landing Light

3. Fault Confirmation
Subtask 33-42-00-710-054-A

A. Do the operational test of the landing lights AMM 33-42-00-710-001.

4. Fault Isolation
Subtask 33-42-00-810-052-A

A. If the test shows that the LANDING LIGHT 7LB (8LB) does not retract:

(1) If there is 115 VAC:

Replace the LT-LANDING, L [7LB] or LT-LANDING, R [8LB] AMM 33-42-11-000-001 and AMM 33-42-11-400-003.

(2) If there is no 115 VAC:

Do a check and repair the wiring between:
SWITCH-LAND/ON/OFF/RETRACT 5LB (6LB) pin 6 and the related LANDING LIGHT connector A/B,
GND and the related LANDING LIGHT connector A/K,
SWITCH-LAND/ON/OFF/RETRACT 5LB (6LB) pin 5 and the CB 3LB (4LB) ASM 334201.

(3) If the fault continues:

Replace the SWITCH-LAND/ON/OFF/RETRACT 5LB or SWITCH-LAND/ON/OFF/RETRACT 6LB (Panel 25VU).

Subtask 33-42-00-710-055-A

B. Do the test as given in the Para. 3. A.

5. Close-up
Subtask 33-42-00-860-052-A

A. Put the aircraft back to its initial configuration.

[Rev.8 from Aug 2018] 2026.04.04 04:31:58 UTC