Jerky Steering

TASK 32-51-00-810-825-A
Jerky Steering

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 32-51-00-820-002	Adjustment of the N/WS Zero Position with Adjusting Tool F26630200 for A/C with N/WS Feedback Sensor-Box P/N C24763000, NLG Centering Cams as Reference
AMM 32-51-11-000-001	Removal of the Transmitter Unit - Nose-Wheel Steering Handwheel
AMM 32-51-11-400-001	Installation of the Transmitter Unit - Nose-Wheel Steering Handwheel
AMM 32-51-19-220-001	Check of the Voltage at the Nose Wheel Steering Feedback Sensor
AMM 32-51-51-000-001	Removal of the Nose-Wheel Steering Servo-Control
AMM 32-51-51-400-001	Installation of the Nose-Wheel Steering Servo-Control

3. Fault Confirmation
Subtask 32-51-00-710-054-A

A. Test
Not applicable.

4. Fault Isolation
Subtask 32-51-00-810-078-A

A. If jerky steering occurs:

Do a check of the voltage at the nose wheel steering feedback sensor 3GC AMM 32-51-19-220-001

(1) If voltage is out of the specified limits:

do the adjustment of the nose wheel steering "zero" position AMM 32-51-00-820-002

(2) If voltage is correct:

replace the XMTR UNIT-N/W STRG HANDWHEEL,CAPT [1GC] AMM 32-51-11-000-001 AMM 32-51-11-400-001

(a) If the fault continues

replace the XMTR UNIT-N/W STRG HANDWHEEL,F/O [2GC] AMM 32-51-51-000-001 AMM 32-51-51-400-001.

(b) If the fault continues:

[Rev.8 from Aug 2018] 2026.04.04 04:31:49 UTC