Failure of the F/O PFD Detected by the DMC3

TASK 31-63-81-810-851-A
Failure of the F/O PFD Detected by the DMC3

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 31-60-00-740-002	Perform Electronic Instrument System (EIS) Input Test
AMM 31-60-00-740-004	EIS System Test
ASM 316104
AMM 31-63-22-000-001	Removal of the Display Unit
AMM 31-63-22-400-001	Installation of the Display Unit
AMM 31-63-34-000-001	Removal of the DMC
AMM 31-63-34-400-001	Installation of the DMC

3. Fault Confirmation
Subtask 31-63-81-740-150-A ** ON A/C NOT FOR ALL

A. Test
Do the EIS input test AMM 31-60-00-740-002.

Subtask 31-63-81-740-150-B ** ON A/C NOT FOR ALL

A. Test
Do the EIS system test AMM 31-60-00-740-004.

4. Fault Isolation
Subtask 31-63-81-810-108-A

A. If the test gives the maintenance message DMC3-DU PFD2 LINK:

(1) If this test gives the maintenance message DMC3-DU PFD2 LINK:

(a) If the fault continues:

do a check of the wiring from DMC2 (1WT2) pins AB/10B, 10C to the first terminal block ASM 316104.

1 If there is no continuity:

2 If there is continuity:

do a check of the wiring from DMC2 (1WT2) pins AB/10D, 10E to the first terminal block ASM 316104.

a If there is no continuity:

b If there is continuity:

do a check and repair the wiring from the DMC2 (1WT2) to the DMC3 (1WT3):
. pins AB/10H, 10J to pins AB/9B, 9C
. pins AB/10F, 10G to pins AB/9D, 9E ASM 316104.

(2) If this test gives no maintenance message:

(a) If the fault continues:

do a check of the wiring from F/O PFD (2WT2) pins AA/21, 22 to the first terminal block ASM 316104.

1 If there is no continuity:

2 If there is continuity:

do a check and repair the wiring from F/O PFD (2WT2) pins AA/23, 24 to the first terminal block ASM 316104.

Subtask 31-63-81-740-151-A

B. Do the test given in Para. 3.

[Rev.8 from Aug 2018] 2026.04.04 04:30:58 UTC