Loss of the ENG2 N1 Indication on the Upper ECAM DU Detected by the DMC

TASK 31-63-81-810-805-A
Loss of the ENG2 N1 Indication on the Upper ECAM DU Detected by the DMC

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 31-60-00-740-002	Perform Electronic Instrument System (EIS) Input Test
AMM 31-60-00-740-004	EIS System Test
ASM 316104
AMM 31-63-22-000-001	Removal of the Display Unit
AMM 31-63-22-400-001	Installation of the Display Unit
AMM 31-63-34-000-001	Removal of the DMC
AMM 31-63-34-400-001	Installation of the DMC

3. Fault Confirmation
Subtask 31-63-81-740-058-A ** ON A/C NOT FOR ALL

A. Test
Do the EIS input test AMM 31-60-00-740-002.

Subtask 31-63-81-740-058-B ** ON A/C NOT FOR ALL

A. Test
Do the EIS system test AMM 31-60-00-740-004.

4. Fault Isolation
Subtask 31-63-81-810-056-A

A. If the test gives the maintenance message DMC3 : ENG2 N1 DSPLY ERR:

on the ECAM control panel, set the UPPER DISPLAY potentiometer to OFF and do the test given in Para. 3.

(1) If this test gives the maintenance message DMC3 : ENG2 N1 DSPLY ERR:

(a) If the fault continues:

do a check of the wiring from the DMC3 (1WT3) to the DMC1 (1WT1):
. pins AB/11B, 11C to pins AB/11J, 11H
. pins AB/11D, 11E to pins AB/11F, 11G ASM 316104.

1 If there is no continuity:

2 If there is continuity:

do a check of the wiring from DMC1 (1WT1) pins AB/11B, 11C to the first terminal block.

a If there is no continuity:

b If there is continuity:

do a check and repair the wiring from DMC1 (1WT1) pins AB/11D, 11E to the first terminal block.

(2) If this test gives no maintenance message:

(a) If the fault continues:

do a check of the wiring from upper ECAM DU (4WT1) pins AA/35, 36 to the first terminal block.

1 If there is no continuity:

2 If there is continuity:

do a check and repair the wiring from upper ECAM DU (4WT1) pins AA/38, 39 to the first terminal block ASM 316104.

Subtask 31-63-81-740-059-A

B. Do the test given in Para. 3.

[Rev.8 from Aug 2018] 2026.04.04 04:30:53 UTC