Loss of the input bus from the SDAC 2 to the DMC 2

TASK 31-63-00-810-930-A
Loss of the input bus from the SDAC 2 to the DMC 2

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
ASM 315404
AMM 31-60-00-740-002	Perform Electronic Instrument System (EIS) Input Test
AMM 31-60-00-740-007	GROUND SCANNING Test of the DMC
AMM 31-63-34-000-001	Removal of the DMC
AMM 31-63-34-400-001	Installation of the DMC

3. Fault Confirmation
Subtask 31-63-00-865-162-A

A. Make sure that this(these) circuit breaker(s) is(are) closed:

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
121VU	EIS/SDAC/2/SPLY	2WV	Q06

Subtask 31-63-00-740-270-A ** ON A/C NOT FOR ALL

B. Test
Do the EIS input test (EIS 2) AMM 31-60-00-740-002.

Subtask 31-63-00-740-270-B ** ON A/C NOT FOR ALL

B. Test
Do the Ground Scanning Test of the DMC AMM 31-60-00-740-007.

4. Fault Isolation
Subtask 31-63-00-810-178-A ** ON A/C NOT FOR ALL

A. If the test gives the maintenance message:
DMC 2 : NO SDAC2 DATA

(1) If the fault continues:

do a check and repair the wiring from the DMC 2 (1WT2) pins AA/10G, 10H to the first terminal block , ASM 315404.

Subtask 31-63-00-810-178-B ** ON A/C NOT FOR ALL

A. If the test gives the maintenance message:
SDAC2(1WV2)/DMC2(1WT2)

(1) If the fault continues:

do a check and repair the wiring from the DMC 2 (1WT2) pins AD/6C, 6D to the first terminal block , ASM 315404.

Subtask 31-63-00-740-271-A

B. Do the test given in Para. 3.B.

[Rev.8 from Aug 2018] 2026.04.04 04:30:47 UTC