Loss of the FAC 2 Output Bus by the DMC 1

TASK 31-63-00-810-904-A
Loss of the FAC 2 Output Bus by the DMC 1

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
ASM 226501
AMM 31-60-00-740-002	Perform Electronic Instrument System (EIS) Input Test
AMM 31-60-00-740-007	GROUND SCANNING Test of the DMC
ASM 316201
AMM 31-63-34-000-001	Removal of the DMC
AMM 31-63-34-400-001	Installation of the DMC

3. Fault Confirmation
Subtask 31-63-00-865-136-A

A. Make sure that this(these) circuit breaker(s) is(are) closed:

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
121VU	AUTO FLT/FAC2/28VDC	5CC2	M19
121VU	AUTO FLT/FAC2/26VAC	14CC2	M18

Subtask 31-63-00-740-218-A ** ON A/C NOT FOR ALL

B. Test
Do the EIS input test AMM 31-60-00-740-002.

Subtask 31-63-00-740-218-B ** ON A/C NOT FOR ALL

B. Test
Do the Ground Scanning Test of the DMC AMM 31-60-00-740-007.

4. Fault Isolation
Subtask 31-63-00-810-152-A ** ON A/C NOT FOR ALL

A. If the test gives the maintenance message DMC 1 : NO FAC 2 DATA:

(1) If the fault continues:

do a check and repair the wiring from the DMC 1 (1WT1) pins AA/3G, 3H to the first terminal block ASM 316201.

(2) If the fault continues:

do a check and repair the wiring from the DMC 1 (1WT1) pin AB/2K to the first terminal block ASM 226501.

Subtask 31-63-00-810-152-B ** ON A/C NOT FOR ALL

A. If the test gives the maintenance message FAC2(1CC2)/DMC1(1WT1):

(1) If the fault continues:

do a check and repair the wiring from the DMC 1 (1WT1) pins AA/4J, 4K to the first terminal block ASM 316201.

(2) If the fault continues:

do a check and repair the wiring from the DMC 1 (1WT1) pin AB/5H to the first terminal block ASM 226501.

Subtask 31-63-00-740-219-A

B. Do the test given in Para. 3.B.

[Rev.8 from Aug 2018] 2026.04.04 04:30:45 UTC