Loss of the EEC 1 Channel A Output Bus by the DMC 3

TASK 31-63-00-810-890-A
Loss of the EEC 1 Channel A Output Bus by the DMC 3

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 31-60-00-740-002	Perform Electronic Instrument System (EIS) Input Test
AMM 31-60-00-740-007	GROUND SCANNING Test of the DMC
ASM 316201
AMM 31-63-34-000-001	Removal of the DMC
AMM 31-63-34-400-001	Installation of the DMC

3. Fault Confirmation
Subtask 31-63-00-865-122-A ** ON A/C NOT FOR ALL

A. Make sure that this(these) circuit breaker(s) is(are) closed:

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	ENGINE/1/FADEC A/AND EIU 1	2KS1	A04

Subtask 31-63-00-740-190-A ** ON A/C NOT FOR ALL

B. Test
Do the EIS input test AMM 31-60-00-740-002.

Subtask 31-63-00-740-190-B ** ON A/C NOT FOR ALL

B. Test
Do the Ground Scanning Test of the DMC AMM 31-60-00-740-007.

4. Fault Isolation
Subtask 31-63-00-810-138-D ** ON A/C NOT FOR ALL

A. If the test gives the maintenance message EEC(E1-4000KS)BUS EEC1A/DMC3(1WT3):

(1) If the fault continues:

do a check and repair the wiring from the DMC 3 (1WT3) pins AE/1J, 1K to the first terminal block ASM 316201.

Subtask 31-63-00-810-138-E ** ON A/C NOT FOR ALL

A. If the test gives the maintenance message EEC(E1-4000KS)BUS EEC1A/DMC3(1WT3):

(1) If the fault continues:

Do a check and repair the wiring from the DMC 3 (1WT3) pins AD/1J, 1K to the first terminal block ASM 316201.

Subtask 31-63-00-740-191-A ** ON A/C NOT FOR ALL

B. Do the test given in Para. 3.B.

[Rev.8 from Aug 2018] 2026.04.04 04:30:44 UTC