Loss of the Heating System of the Left Sliding Window
TASK 30-42-00-810-811-A
Loss of the Heating System of the Left Sliding Window
1. Possible Causes
2. Job Set-up Information
A. Referenced Information
3. Fault Confirmation
Subtask 30-42-00-710-070-A
Subtask 30-42-00-810-060-A
[Rev.8 from Aug 2018]
2026.04.04 04:29:41 UTC
Loss of the Heating System of the Left Sliding Window
1. Possible Causes
2. Job Set-up Information
A. Referenced Information
| REFERENCE | DESIGNATION |
|---|---|
| AMM 30-42-00-710-001 | Operational Test of the Windshield Anti-Icing and Defogging |
| ASM 304201 | |
| AMM 30-42-34-000-001 | Removal of the Window Heat Computer (WHC) |
| AMM 30-42-34-400-001 | Installation of the Window Heat Computer (WHC) |
| AMM 56-12-11-000-002 | Removal of the Sliding Window Panel |
| AMM 56-12-11-400-002 | Installation of the Sliding Window Panel |
Subtask 30-42-00-710-070-A
A. Test
(1) Do the operational test of the windshield anti-icing and defogging AMM 30-42-00-710-001.
4. Fault Isolation(1) Do the operational test of the windshield anti-icing and defogging AMM 30-42-00-710-001.
Subtask 30-42-00-810-060-A
A. If the test gives maintenance message L SLIDING WINDOW:
(a) Replace WHC-1 [2DG1] , AMM 30-42-34-000-001 and AMM 30-42-34-400-001.
(b) If the fault continues:
Subtask 30-42-00-710-071-A - Disconnect the electrical connector from the L sliding window (8DG1) and do a check of the resistance between pin A and pin B on the receptacle of the L sliding window (8DG1).
NOTE: For left sliding window P/N NP165312 series,
For left sliding window P/N SPSA320 series 2 (with 2 sensors),
For left sliding window P/N SPSA320 series 3 (with 3 sensors),
For left sliding window P/N NH25216 series,
(1) If the resistance is not correct: For left sliding window P/N SPSA320 series 2 (with 2 sensors),
For left sliding window P/N SPSA320 series 3 (with 3 sensors),
For left sliding window P/N NH25216 series,
- Replace WINDOW-SLIDING, L [8DG1] , AMM 56-12-11-000-002 and AMM 56-12-11-400-002.
(a) Replace WHC-1 [2DG1] , AMM 30-42-34-000-001 and AMM 30-42-34-400-001.
(b) If the fault continues:
- Do a check and repair the
wiring from the WHC 1 (2DG1) to L sliding window (8DG1) pin B/J to pin A/A ASM 304201.
B. Do the operational test given in Para. 3.
L Sliding Window Electrical Connector with 2 sensors