Loss of the F/CTL Page Automatic Call up during Check List

TASK 27-95-00-810-839-A
Loss of the F/CTL Page Automatic Call up during Check List

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 27-95-34-000-001	Removal of the FCDC
AMM 27-95-34-400-001	Installation of the FCDC
AMM 31-50-00-710-001	Ground Scanning of the Central Warning System
AMM 31-55-34-000-001	Removal of the SDAC
AMM 31-55-34-400-001	Installation of the SDAC
AMM 31-63-34-000-001	Removal of the DMC
AMM 31-63-34-400-001	Installation of the DMC

3. Fault Confirmation
Subtask 27-95-00-700-054-A

A. Not applicable. The fault is evident during the check list with the engines in operation.

4. Fault Isolation
Subtask 27-95-00-810-095-A

A. If the F/CTL page does not come into view automatically during the check list (Flight Phase 02):

Subtask 27-95-00-810-096-A

B. If there is a warning:

No maintenance action is necessary. Do the trouble shooting related to the warning (Ref 27 ECAM).

Subtask 27-95-00-810-097-A ** ON A/C NOT FOR ALL

C. If there is no warning:

(1) If the RUD position symbol is shown:
(a) replace the FCDC-1 [3CE1] AMM 27-95-34-000-001 and AMM 27-95-34-400-001.
(b) If the fault continues:

(2) If the RUD position symbol is not shown:

(a) If the BITE test gives a maintenance message related to the XDCR UNIT-RUDDER POS [42WV] :

(b) If the BITE test does not give a maintenance message related to the XDCR UNIT-RUDDER POS [42WV]

Subtask 27-95-00-810-097-B ** ON A/C NOT FOR ALL

C. If there is no warning:

(1) If the RUD position symbol is shown:
(a) replace the FCDC-1 [3CE1] AMM 27-95-34-000-001 and AMM 27-95-34-400-001.
(b) If the fault continues:

(2) If the RUD position symbol is not shown:

(a) If the BITE test gives a maintenance message related to the XDCR UNIT-RUDDER POS [42WV] :

(b) If the BITE test does not give a maintenance message related to the XDCR UNIT-RUDDER POS [42WV]

[Rev.8 from Aug 2018] 2026.04.04 04:28:25 UTC