Loss of the Signal of the Right Yellow Elevator-Servocontrol Servovalve by the SEC 2

TASK 27-94-00-810-922-A
Loss of the Signal of the Right Yellow Elevator-Servocontrol Servovalve by the SEC 2

1. Possible Causes

SEC-2 [1CE2]
wiring of the R ELEV SV (ANO 2) signal from the SEC 2 (1CE2) COM part to the MON part
wiring from the SEC 2 (1CE2) MON part, pins AD/2F, 2G to the first terminal block
wiring of the LVDT SV SPLY (34CE2) signal, from the SEC 2 (1CE2) to the first terminal block
wiring of the LVDT POS (ANI 3-2) signal, from the SEC 2 (1CE2) MON part to the first terminal block

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
ASM 279408
AMM 27-94-34-000-001	Removal of the SEC
AMM 27-94-34-400-001	Installation of the SEC
AMM 27-96-00-710-020	Operational Test of the Side Stick Assembly (Activation for the BITE Test)
AMM 27-96-00-740-001	BITE Test of the EFCS (Ground Scanning)

3. Fault Confirmation
Subtask 27-94-00-700-137-A

A. Test
(1) Do the operational test of the side stick assembly (Activation for the BITE test) AMM 27-96-00-710-020.

NOTE: Before you start the operational test procedure, release the FLT CTL/ELAC 1 and FLT CTL/ELAC 2 pushbutton switches (on these pushbutton switches the OFF legends come on).

(2) Do the BITE test of the EFCS (ground scanning) AMM 27-96-00-740-001.

4. Fault Isolation
Subtask 27-94-00-810-167-A

A. If the test gives the maintenance message:
SEC2-COM OR WIRING TO R Y ELEV SERVO VLV 34CE2

Replace the SEC-2 [1CE2] AMM 27-94-34-000-001 and AMM 27-94-34-400-001.

(1) If the fault continues:
(a) Do a check of the wiring of the R ELEV SV (ANO 2) signal from the SEC 2 (1CE2) COM part to the MON part, from the pins AA/2A, 2B to the pins AD/2J, 2K ASM 279408:

If there is continuity, go to Para. (b)
If there is no continuity, repair the above wiring.

(b) Do a check of wiring from the SEC 2 (1CE2) MON part, pins AD/2F, 2G to the first terminal block ASM 279408:

If there is continuity go to Para. (c)
If there is no continuity repair the above wiring.

(c) Do a check of the wiring of the LVDT SV SPLY (34CE2) signal, from the SEC 2 (1CE2) to the first terminal block ASM 279408:

If there is continuity go to Para. (d)
If there is no continuity repair the above wiring.

(d) Do a check and repair the wiring of the LVDT POS (ANI 3-2) signal, from the SEC 2 (1CE2) MON part to the first terminal block ASM 279408.

Subtask 27-94-00-700-138-A

B. Do the tests given in Para. 3.

[Rev.8 from Aug 2018] 2026.04.04 04:28:22 UTC