Loss of the Yellow Hydraulic Pressure Transducer Signal for the ELAC 2

TASK 27-93-00-810-830-A
Loss of the Yellow Hydraulic Pressure Transducer Signal for the ELAC 2

1. Possible Causes

ELAC-2 [2CE2]
wiring of the ANI 4-5 signal from the ELAC 2 (2CE2) COM and MON parts to the first terminal block

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
ASM 279228
AMM 27-93-34-000-001	Removal of the ELAC
AMM 27-93-34-400-001	Installation of the ELAC
AMM 27-96-00-740-001	BITE Test of the EFCS (Ground Scanning)
AMM 29-10-00-863-002	Pressurize the Yellow Hydraulic System with a Hydraulic Ground Power-Cart
AMM 29-10-00-864-002	Depressurize the Yellow Hydraulic System

3. Fault Confirmation
Subtask 27-93-00-860-072-A

A. Job Set-Up
(1) Pressurize the Yellow hydraulic system AMM 29-10-00-863-002.

Subtask 27-93-00-740-080-A

B. Test
(1) Do the BITE test of the EFCS (Ground Scanning) AMM 27-96-00-740-001.
(a) If the test gives a maintenance message, do the step 4. Fault Isolation.
(b) If there is no maintenance message:
1 No other maintenance action is necessary.
2 If the fault history report shows that the same failure occurred more than three times, replace the ELAC-2 [2CE2] .

4. Fault Isolation
Subtask 27-93-00-810-079-B

A. If the BITE test gives the maintenance message:
ELAC2 OR WIRING FROM Y HYD PRESS XMTR 3065GN

replace the ELAC-2 [2CE2] , AMM 27-93-34-000-001 and AMM 27-93-34-400-001.

(1) If the fault continues:

do a check and repair the wiring of the ANI 4-5 signal from the ELAC 2 (2CE2) COM and MON parts to the first terminal block, ASM 279228.

Subtask 27-93-00-740-081-A

B. Do the test given in Para. 3.

5. Close-up
Subtask 27-93-00-860-073-A

A. Depressurize the Yellow hydraulic system AMM 29-10-00-864-002.

[Rev.8 from Aug 2018] 2026.04.04 04:27:57 UTC