Ground Fault Interupt detected
TASK 25-21-00-810-870-A
Ground Fault Interupt detected
1. Possible Causes
A. Referenced Information
3. Fault Confirmation
Subtask 25-21-00-740-053-B ** ON A/C NOT FOR ALL 4. Fault Isolation
Subtask 25-21-00-810-244-E ** ON A/C NOT FOR ALL
[Rev.8 from Aug 2018]
2026.04.04 04:39:05 UTC
Ground Fault Interupt detected
1. Possible Causes
- Seat-to-seat cable
- In-seat cable
- Wiring
- terminal blocks VT-type
A. Referenced Information
| REFERENCE | DESIGNATION |
|---|---|
| TSM TASK 24-00-00-810-803-A | Circuit Breaker Tripped and/or C/B TRIPPED Warning |
| ASM 252100 | |
| AMM 25-21-00-740-001 | BITE Test of the Master Control Unit (MCU) |
| AWM 252133 | |
| AWM 252134 | |
| AWM 252137 | |
| AWM 252138 | |
| AWM 252141 | |
| AWM 252142 | |
| AWM 252145 | |
| AWM 252146 | |
| AMM 25-21-61-000-001 | Removal of the Cable - Seat to Seat |
| AMM 25-21-61-400-001 | Installation of the Cable - Seat to Seat |
Subtask 25-21-00-740-053-B ** ON A/C NOT FOR ALL 4. Fault Isolation
Subtask 25-21-00-810-244-E ** ON A/C NOT FOR ALL
A. If the BITE test confirms the fault, refer to the indication panel and the circuit breaker panel of the MCU:
(1) If the circuit breakers are open:
(a) Do a check (Ref. TSM TASK 24-00-00-810-803) and repair or replace the defective:
(b) Do a check and repair or replace the defective:
1 Do a careful check of the terminal blocks VT-type for correct condition and correct connection.
2 Make sure that all terminal ends and the nuts are correctly installed and repair if necessary.
Subtask 25-21-00-710-107-A ** ON A/C NOT FOR ALL (1) If the circuit breakers are open:
(a) Do a check (Ref. TSM TASK 24-00-00-810-803) and repair or replace the defective:
- Seat-to-seat cable AMM 25-21-61-000-001 and AMM 25-21-61-400-001
- In-seat cable .
- Wiring between the MCU and the power wall disconnect-box (PWDB).
- The PORT BITE LED(s) and the POWER PORT STATE LED(s) are OFF, or
- The PORT BITE LED(s) flashes GREEN and the GENERAL BITE LED is OFF.
(b) Do a check and repair or replace the defective:
- Seat-to-seat cable AMM 25-21-61-000-001 and AMM 25-21-61-400-001
- In-seat cable .
- Wiring between the MCU and the PWDB.
1 Do a careful check of the terminal blocks VT-type for correct condition and correct connection.
2 Make sure that all terminal ends and the nuts are correctly installed and repair if necessary.
B. Do the test given in Para. 3.