W DOC AIRBUS | TSM A320F

Failure of the APU Generator Feeders or APU Generator POR-Wiring

TASK 24-41-00-810-824-A
Failure of the APU Generator Feeders or APU Generator POR-Wiring

1. Possible Causes
  • wiring
  • feeders
  • GAPCU [24XG]
2. Job Set-up Information
 A. Referenced Information
REFERENCE
DESIGNATION
ASM 242301
AMM 24-41-00-861-002
Energize the Aircraft Electrical Circuits from the External Power
AMM 24-41-00-862-002
De-energize the Aircraft Electrical Circuits Supplied from the External Power
AMM 24-41-34-000-001
Removal of the Ground Power Control Unit (GPCU)
AMM 24-41-34-400-001
Installation of the Ground Power Control Unit (GPCU)
3. Fault Confirmation
Subtask 24-41-00-869-053-A ** ON A/C NOT FOR ALL
A. Test
Not applicable.
NOTE: As the APU GEN was set to OFF because of a true failure, the fault confirmation is not necessary.
4. Fault Isolation
Subtask 24-41-00-810-067-D ** ON A/C NOT FOR ALL
A. If the fault symptom is identified by the CFDS message WRG: POR/ WRG: APU GEN FEEDER/ GAPCU (24XG) and the upper ECAM-DU warning APU GEN FAULT:
  • Do a check of the Point-Of-Regulation (POR) sense wiring ASM 242301 for a correct phase connection between:
    . Pin 7 of the APU/EXT power contactor module (29XN) and pin A/14G of the GAPCU (phase A)
    . Pin 8 of the APU/EXT power contactor module and pin A/15H of the GAPCU (phase B)
    . Pin 9 of the APU/EXT power contactor module and pin A/15G of the GAPCU (phase C).
   (1) If the wiring is not correct:
  • Connect the wiring as necessary to get the correct phase sequence.
   (2) If the wiring is correct:
  • Do a check of the APU generator feeders ASM 242301 for a correct phase connection between:
    . Terminal T1 of the APU generator and pin 7 of the APU/EXT power contactor module (29XN)
    . Terminal T2 of the APU generator and pin 8 of the APU/EXT power contactor module
    . Terminal T3 of the APU generator and pin 9 of the APU/EXT power contactor module.
     (a) If the wiring is not correct:
  • Connect the wiring as necessary to get the correct phase sequence.
     (b) If the wiring is correct:
Subtask 24-41-00-860-053-A ** ON A/C NOT FOR ALL
B. Make sure that the aircraft electrical circuits operate correctly in APU configuration.
   (1) Energize the aircraft electrical circuits from the APU AMM 24-41-00-861-002.
   (2) Let the APU generator operate for five minutes to make sure that it operates correctly.
   (3) De-energize the aircraft electrical circuits from the APU AMM 24-41-00-862-002.
[Rev.8 from Aug 2018] 2026.04.04 04:26:54 UTC
"WTRUIB" 2025