LGCIU2/RMP3 interface fault

TASK 23-13-00-810-858-A
LGCIU2/RMP3 interface fault

1. Possible Causes

LGCIU-2 [5GA2]
[1RG3]

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
ASM 231300
AMM 23-13-00-740-001	BITE Test of the Radio Management
AMM 23-13-13-000-001	Removal of the Radio Management Panel (RMP)
AMM 23-13-13-400-001	Installation of the Radio Management Panel (RMP)
AMM 32-31-71-000-001	Removal of the LGCIU
AMM 32-31-71-400-001	Installation of the LGCIU

3. Fault Confirmation
Subtask 23-13-00-740-138-A

A. Test
(1) Do the BITE test of the RMP AMM 23-13-00-740-001.

NOTE: If the BITE test of the RMP passes, i.e. if the test result is OK, the RMP is operational, therefore should not be removed. Refer to TFU 23.13.00.023.

4. Fault Isolation
Subtask 23-13-00-810-097-A

A. If the test gives the maintenance message LGCIU1(5GA1)/RMP1(1RG1):

Replace the LGCIU-2 [5GA2] AMM 32-31-71-000-001 and AMM 32-31-71-400-001.

(1) If the fault continues:

Replace the [1RG3] AMM 23-13-13-000-001 and AMM 23-13-13-400-001.

(2) If the fault continues:

Remove the LGCIU-2 [5GA2] AMM 32-31-71-000-001
Remove the [1RG3] AMM 23-13-13-000-001
Do a check and repair the wiring of the GROUND AIR DISCRET INPUT signal from AB/9C of the LGCIU2 to pin A/<E of the RMP3 ASM 231300.
Install the [1RG3] AMM 23-13-13-400-001.
Install the LGCIU-2 [5GA2] AMM 32-31-71-400-001.

[Rev.8 from Aug 2018] 2026.04.04 04:25:41 UTC