Failure of the RMP 2 (RMP 1 Source)

TASK 23-13-00-810-802-A
Failure of the RMP 2 (RMP 1 Source)

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
AMM 23-13-00-740-001	BITE Test of the Radio Management
ASM 231301
AMM 23-13-13-000-001	Removal of the Radio Management Panel (RMP)
AMM 23-13-13-400-001	Installation of the Radio Management Panel (RMP)

3. Fault Confirmation
Subtask 23-13-00-865-066-A

A. Table of the circuit breakers used in this procedure:

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
121VU	COM NAV/RMP/2	2RG2	L02

Subtask 23-13-00-860-051-A

B. Job Set-Up
On the RMP 1 and RMP 2 only, make sure that the ON/OFF switches are at ON.

Subtask 23-13-00-740-052-A

C. Test
Do the BITE test of the Radio Management AMM 23-13-00-740-001.

NOTE: Do this test for the RMP 1 only.

4. Fault Isolation
Subtask 23-13-00-810-051-B

A. If the test gives the maintenance message RMP2(1RG2)/RMP1(1RG1):

(1) If the circuit breaker (2RG2) is closed:

(a) If there is 28VDC:

replace the RMP-COM/NAV FREQ SEL, 2 [1RG2] AMM 23-13-13-000-001 and AMM 23-13-13-400-001.

(b) If there is no 28VDC:

1 If there is no ground signal:

repair the wiring between the RMP 2 (1RG2) pin A/R and the ground terminal ASM 231301.

2 If there is a ground signal:

do a check of the wiring between the RMP 2 pin A/N and the circuit breaker (2RG2) ASM 231301.

a If there is no continuity:

b If there is continuity:

(2) If the circuit breaker (2RG2) is open:

(a) If it opens again:

1 If the fault continues:

do a check for a short to ground at the wiring between the RMP (1RG) pin A/N and the circuit breaker (2RG2) ASM 231301.

a If there is a short to ground:

b If there is no short to ground:

(b) If the circuit breaker stays closed and the fault continues:

Subtask 23-13-00-740-053-A

B. Do the test given in Para. 3.B.

[Rev.8 from Aug 2018] 2026.04.04 04:25:39 UTC