Loss of the Power Supply 26VAC of the Rudder Travel Limiting Side 1

TASK 22-61-00-810-805-A
Loss of the Power Supply 26VAC of the Rudder Travel Limiting Side 1

1. Possible Causes

2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
ASM 226701
AMM 22-91-00-710-001	Ground Scanning of the AFS
AMM 27-23-51-000-001	Removal of the Rudder Travel Limitation Unit
AMM 27-23-51-000-002	Removal of the Electronic Module of the Rudder Travel Limitation Unit
AMM 27-23-51-400-001	Installation of the Rudder Travel-Limitation Unit
AMM 27-23-51-400-002	Installation of the Electronic Module of the Rudder Travel Limitation Unit

3. Fault Confirmation
Subtask 22-61-00-710-060-A

A. Test
(1) Do the Ground Scanning of the AFS AMM 22-91-00-710-001.

4. Fault Isolation
Subtask 22-61-00-810-056-A

A. If the test gives the maintenance message AFS : 431 XPA BUS BAR:

replace the electronic module of the rudder travel-limitation unit (4CC) AMM 27-23-51-000-002 and AMM 27-23-51-400-002.

(1) If the fault continues:

replace the LIMITATION UNIT-RUDDER TRAVEL [4CC] , AMM 27-23-51-000-001 and AMM 27-23-51-400-001.

(2) If the fault continues:

do a check of the wiring of the 26VAC signal at the rudder travel-limitation unit (4CC) from pin A/K to the first terminal block ASM 226701.

(a) If there is no continuity:

(b) If there is continuity:

do a check and repair the wiring of the ground signal at rudder travel-limitation unit (4CC) pin A/V ASM 226701.

Subtask 22-61-00-710-061-A

B. Do the test given in Para. 3.

[Rev.8 from Aug 2018] 2026.04.04 04:25:11 UTC