W DOC AIRBUS | TSM A320F

Outflow Valve Fault (33) (81)


TASK 21-31-00-810-828-A
Outflow Valve Fault (33) (81)


1. Possible Causes
  • OUTFLOW VALVE [10HL]
2. Job Set-up Information
 A. Referenced Information
REFERENCE
DESIGNATION
AMM 21-31-51-000-001
Removal of the Outflow Valve (From Inside)
AMM 21-31-51-000-006
Removal of the Outflow Valve (From Outside)
AMM 21-31-51-400-001
Installation of the Outflow Valve (From Inside)
AMM 21-31-51-400-006
Installation of the Outflow Valve (From Outside)
AMM 38-32-00-790-001
Leak Test of the Waste/Water Drain System
3. Fault Confirmation
Subtask 21-31-00-710-104-A
A. The fault cannot be reproduced on the ground.
4. Fault Isolation
Subtask 21-31-00-810-178-A ** ON A/C NOT FOR ALL
A. If one or both of the reports, LAST LEG REPORT, PREVIOUS LEG REPORT gives the maintenance messages OUTFLOW VALVE (33) and/or OUTFLOW VALVE (81):
   (1) Do a visual inspection of the outflow valve (10HL) mechanism body for ice or water. If ice or water is found on the outflow valve:
  • remove the ice or water and dry the area.
  • do a check of the waste/water drain system for leakages AMM 38-32-00-790-001.
   (2) If no ice or water is found on the outflow valve:
NOTE: It is necessary to do the tests of the Pressure Control and Monitoring System on the two system channels at the end of the installation procedure.
  • After the subsequent flight, make sure that the fault does not continue.
Subtask 21-31-00-810-178-B ** ON A/C NOT FOR ALL
A. If one or both of the reports, LAST LEG REPORT, PREVIOUS LEG REPORT gives the maintenance messages OUTFLOW VALVE (33) and/or OUTFLOW VALVE (81):
   (1) Do a visual inspection of the outflow valve (10HL) mechanism body for ice or water. If ice or water is found on the outflow valve:
  • remove the ice or water and dry the area.
  • do a check of the waste/water drain system for leakages AMM 38-32-00-790-001.
   (2) If no ice or water is found on the outflow valve:
NOTE: It is necessary to do the tests of the Pressure Control and Monitoring System on the two system channels at the end of the installation procedure.
  • After the subsequent flight, make sure that the fault does not continue.
[Rev.8 from Aug 2018] 2026.04.04 04:38:50 UTC