Installation of the Thrust Reverser Lockout Fairing [CFMB]

TASK 78-30-00-440-804-B
Installation of the Thrust Reverser Lockout Fairing

1. Reason for the Job
CDL 78-11
Thrust Reverser Lockout Fairing
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 1M(3 FT)
No specific	AR	WARNING NOTICE(S)
No specific	Torque wrench: range to between 17 and 15 lbf.in (0.19 and 0.17 m.daN )

B. Referenced Information

REFERENCE	DESIGNATION
Lockout Fairings

3. Job Set-up
Subtask 78-30-00-941-081-A ** ON A/C NOT FOR ALL

A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Make sure that a WARNING NOTICE(S) is in position to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than five minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Make sure that a WARNING NOTICE(S) is in position to tell persons not to energize the FADEC 1(2).

Subtask 78-30-00-010-085-A ** ON A/C NOT FOR ALL

B. Get Access
(1) Put the ACCESS PLATFORM 1M(3 FT) in position.

4. Procedure
Subtask 78-30-00-420-056-A ** ON A/C NOT FOR ALL

A. Installation of the Thrust Reverser Lockout Fairings
(1) Attach the four lockout fairings (2) to the blocker door with the four screws (1).
(2) TORQUE the four screws (1) to between 17 and 15 lbf.in (0.19 and 0.17 m.daN )

5. Close-up
Subtask 78-30-00-942-053-A ** ON A/C NOT FOR ALL

A. Close Access
(1) Make sure that the work area is clean and clear of tools and other items.

[Rev.10 from 2021] 2026.04.01 03:23:54 UTC