Preservation of the Fuel Pump and Filter Assembly [CFMI]

TASK 73-11-10-620-001-A
Preservation of the Fuel Pump and Filter Assembly

1. Reason for the Job
To put the fuel pump and filter assembly in storage after removal from the engine.
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	PLUG - BLANKING
856A3471	1	ADAPTER-DRIVE SPLINES FUEL PUMP ROTATION CHECK

B. Consumable Materials

REFERENCE	DESIGNATION
(Material No.CP2101)	graphite grease
(Material No.CP5066)	fuel system preventative

3. Job Set-up
Subtask 73-11-10-869-051-A ** ON A/C NOT FOR ALL

A. Not Applicable

4. Procedure
Subtask 73-11-10-620-050-A ** ON A/C NOT FOR ALL

A. Preservation of fuel pump
(1) Flush with fuel system preventative (Material No.CP5066) . Before use on the pump, put the preventive fluid through a 10 micron filter. Flush the pump as follows.
(a) Put the fluid into the inlet port of pump.
(b) Use 856A3471 ADAPTER-DRIVE SPLINES FUEL PUMP ROTATION CHECK (856A3471P01/P02), and turn the main drive shaft until the fluid flows out of discharge port.
(c) Tilt the pump and drain out as much fluid as possible.
(d) Install PLUG - BLANKING.
(2) Apply a thin layer of graphite grease (Material No.CP2101) to the splines of the main drive shaft and the HMU drive shaft.

[Rev.10 from 2021] 2026.04.01 13:04:43 UTC