Removal of the Air Starter/Blow Out Door (438BR) [IAE]

TASK 71-13-17-000-010-A
Removal of the Air Starter/Blow Out Door (438BR)

WARNING: BE CAREFUL WHEN YOU DO WORK ON THE ENGINE PARTS AFTER THE ENGINE SHUTDOWN. USE APPLICABLE THERMAL GLOVES. THE ENGINE PARTS CAN STAY HOT FOR ONE HOUR AFTER SHUTDOWN AND CAN BURN YOU.

FIN: 1000EM1 ** ON A/C NOT FOR ALL
FIN: 1000EM2 ** ON A/C NOT FOR ALL

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
FOR [1000EM1] (ENGINE-1)
437AL, 438AR
FOR [1000EM2] (ENGINE-2)
447AL, 448AR

C. Referenced Information

REFERENCE	DESIGNATION
TASK 71-13-00-010-010-A	Opening of the Fan Cowls 437AL(447AL),438AR(448AR)
Air Starter/Blow Out Door

3. Job Set-up
Subtask 71-13-17-941-050-A ** ON A/C NOT FOR ALL

A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a WARNING NOTICE(S) to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a WARNING NOTICE(S) to tell persons not to energize the FADEC 1(2).

Subtask 71-13-17-010-050-A ** ON A/C NOT FOR ALL

B. Open the fan cowls (Ref. AMM TASK 71-13-00-010-010).
(1) FOR [1000EM1] (ENGINE-1)
437AL 438AR
(2) FOR [1000EM2] (ENGINE-2)
447AL 448AR.

4. Procedure
Subtask 71-13-17-020-050-A ** ON A/C NOT FOR ALL

A. Removal of the air starter/blow out door
(1) Remove the air starter/blow out door (1).
(a) Release the latches (2).
(b) Remove and discard the split pins (8).
(c) Remove the collars (7).
(d) Remove the hinge pins (6).
(e) Remove the door from the fan cowl.
(2) Remove and keep these parts for installation to the replacement air starter/ blow out door.
(a) Remove the nuts (5), the washers (3) and the screws (4).
(b) Remove the latches (2) from the door.

[Rev.10 from 2021] 2026.04.01 02:30:00 UTC