SPOP 157 - Application of Zinc Molybdate Primer (AMS 3117) [PW11]

TASK 70-28-00-910-806-A
SPOP 157 - Application of Zinc Molybdate Primer (AMS 3117)

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	BRUSH - BRISTLED, SOFT

B. Consumable Materials

REFERENCE	DESIGNATION
(Material No.P05-005)	lint-free cotton cloth
(Material No.P05-496)	solvent, mineral spirits
(Material No.P18-023)	primer, zinc molybdate

3. Job Set-up
Subtask 70-28-00-860-054-A ** ON A/C NOT FOR ALL

A. Not Applicable

4. Procedure
Subtask 70-28-00-910-054-A ** ON A/C NOT FOR ALL

A. Application of Zinc Molybdate Primer (AMS 3117)
(1) Fully mix the P18-023primer, zinc molybdate.
(2) If necessary, add the P05-496solvent, mineral spirits to decrease the viscosity of the P18-023primer, zinc molybdate to make it easier to apply the P18-023primer, zinc molybdate.
(3) Apply the P18-023primer, zinc molybdate with a BRUSH - BRISTLED, SOFT or swab to give a full layer of primer on the areas where primer is necessary.
(4) Assemble the parts while the P18-023primer, zinc molybdate is wet.
(5) Use a lint-free cotton cloth (Material No.P05-005) to remove unwanted wet P18-023primer, zinc molybdate.

[Rev.10 from 2021] 2026.04.01 02:20:37 UTC