Removal of the NACA Duct Panel

TASK 57-41-37-000-005-A
Removal of the NACA Duct Panel

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	ACCESS PLATFORM 3M (10 FT)
No specific	AR	SAFETY BARRIER(S)
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	WARNING NOTICE(S)
98D27803500001	1	LOCKING TOOL ZERO POS

B. Referenced Information

REFERENCE	DESIGNATION
TASK 57-41-37-000-004-A	Removal of the Pressure Relief Panels
NACA Duct Panel 521BB(621BB) - Location and Detail

3. Job Set-up
Subtask 57-41-37-941-065-A

A. Safety Precautions
(1) As necessary, use the applicable SAFETY BARRIERS, specified by the operator's instructions and your local regulations.
(2) Install the 98D27803500001 LOCKING TOOL ZERO POS on the flap/slat control lever.
(3) Put a WARNING NOTICE(S) in the cockpit to tell persons not to operate the slats.

Subtask 57-41-37-865-076-A

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
49VU	FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1	5CV	B06
** ON A/C NOT FOR ALL
49VU	FLIGHT CONTROLS/SLT/CTL AND MONG/SYS1	5CV	B01
** ON A/C ALL
121VU	FLIGHT CONTROLS/SLT/CTL/SYS2	7CV	R21

4. Procedure
Subtask 57-41-37-010-063-A

A. Get Access
(1) Put the ACCESS PLATFORM 3M (10 FT) in position below the applicable NACA duct panel 521BB(621BB).
(2) Remove the pressure-relief panels 521AB(621AB) and 521CB(621CB) adjacent to the NACA duct panel (1) (Ref. AMM TASK 57-41-37-000-004).

Subtask 57-41-37-020-057-A

B. Removal of the NACA Duct Panel 521BB(621BB)

NOTE: Some of the screws that hold the NACA duct panel (1) in position are longer than the others. Make a record of the position of each screw as it is removed.

(1) Hold the panel (1). Remove the three screws (2) and the four screws (3).
(2) Carefully remove the panel (1).
(3) Remove the packer (4).

[Rev.10 from 2021] 2026.04.01 02:13:16 UTC