W DOC AIRBUS | AMM A320F

Painting of the Elevator

TASK 55-20-00-370-001-A
Painting of the Elevator

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
  • THE FLIGHT CONTROLS
  • THE FLIGHT CONTROL SURFACES
  • THE LANDING GEAR AND THE RELATED DOORS
  • COMPONENTS THAT MOVE.
MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.
WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS SURFACES ARE CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.
WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS SURFACES ARE CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.
WARNING: YOU MUST PUT ON AND ATTACH A SAFETY HARNESS BEFORE YOU START WORK:
  • ON THE THS OR IN THE REAR FUSELAGE
  • ON TOP OF THE WINGS OR PYLONS.
WITHOUT A SAFETY HARNESS, YOU CAN FALL. THIS CAN KILL YOU OR CAUSE YOU INJURY.
WARNING: THIS PROCEDURE IS IN A CATEGORY KNOWN AS A CRITICAL DESIGN CONFIGURATION CONTROL LIMITATION (CDCCL). YOU MUST KEEP ALL CDCCL ITEMS IN THE APPROVED CONFIGURATION. MAKE SURE THAT THE WEIGHT OF THE ELEVATOR IS IN THE SPECIFIED LIMITS.
WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.
CAUTION: USE THIS PROCEDURE ONLY FOR THE SURFACE AREA SPECIFIED. IT IS NOT PERMITTED TO PAINT THE TOTAL SURFACE OF THE ELEVATOR WHEN THE ELEVATOR IS INSTALLED ON THE AIRCRAFT. IT MUST BE OFF THE AIRCRAFT AND SENT TO THE WORKSHOP.
CAUTION: DO NOT CAUSE DAMAGE TO THE SURFACES. THE COMPONENTS ARE MADE OF CARBONFIBER REINFORCED PLASTIC.
1. Reason for the Job
To paint an area lower than 150000 mm2 (232.50 in2).
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
1
ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE
No specific
AR
SAFETY CLIP - CIRCUIT BREAKER
No specific
1
WARNING NOTICE(S)
98D27309009003
2
COLLAR-DEPTH ACTUATOR
98D27309009004
2
COLLAR-DEPTH ACTUATOR
98D27903500000
2
PIN-SIDE STICK LOCKING
 B. Referenced Information
REFERENCE
DESIGNATION
TASK 29-10-00-864-001-A
Depressurize the Green Hydraulic System
TASK 29-10-00-864-002-A
Depressurize the Yellow Hydraulic System
TASK 29-10-00-864-003-A
Depressurize the Blue Hydraulic System
TASK 51-75-11-100-002-A
Removal of Paint by Abrasion
TASK 51-75-12-300-003-A
Repair of Minor Paint Damage (Topcoat Only)
3. Job Set-up
Subtask 55-20-00-860-063-A
A. Depressurize Hydraulic Systems
   (1) Depressurize the Green, Yellow and Blue hydraulic systems (Ref. AMM TASK 29-10-00-864-001) (Ref. AMM TASK 29-10-00-864-002) (Ref. AMM TASK 29-10-00-864-003).
Subtask 55-20-00-865-064-A
B. Open, safety and tag this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/ELAC1/NORM/SPLY15CE1B11
49VUFLIGHT CONTROLS/THS/ACTR/MOT219CE2B09
49VUFLIGHT CONTROLS/SEC1/NORM/SPLY21CE1B08
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/ELAC1/NORM/SPLY15CE1B06
49VUFLIGHT CONTROLS/THS/ACTR/MOT219CE2B04
49VUFLIGHT CONTROLS/SEC1/NORM/SPLY21CE1B03
** ON A/C ALL
105VUFLIGHT CONTROLS/ELAC2/STBY SPLY16CE2A02
105VUFLT CTL/ELAC1/STBY SPLY16CE1A01
105VUFLT CTL/SEC1/STBY SPLY22CEB01
121VUFLIGHT CONTROLS/SEC3/SPLY21CE3Q19
121VUFLIGHT CONTROLS/SEC2/SPLY21CE2Q18
121VUFLIGHT CONTROLS/THS ACTR/MOT319CE3Q17
121VUFLIGHT CONTROLS/THS ACTR/MOT119CE1Q16
121VUFLIGHT CONTROLS/ELAC2/NORM/SPLY15CE2R20
Subtask 55-20-00-481-056-A
C. Install Locking Devices
   (1) Put the 98D27903500000 PIN-SIDE STICK LOCKING in the CAPT and F/O side stick controllers.
   (2) Install the 98D27309009003 COLLAR-DEPTH ACTUATOR or 98D27309009004 COLLAR-DEPTH ACTUATOR on the servocontrol elevators.
Subtask 55-20-00-941-056-A
D. Safety Precautions
   (1) Put the WARNING NOTICE(S) in the flight compartment to tell persons not to operate the flight controls.
   (2) Put the WARNING NOTICE(S) in position to tell persons not to operate the hydraulic systems.
   (3) Put the ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE in position at zone 330 for the left hand elevator and/or zone 340 for the right hand elevator.
4. Procedure
Subtask 55-20-00-370-050-A
A. Painting of the elevator
NOTE: Do this procedure when the area to paint is lower than 150000 mm2 (232.50 in.2).
   (1) Remove the old paint from the area affected (Ref. AMM TASK 51-75-11-100-002).
   (2) Repair the minor paint damages (Ref. AMM TASK 51-75-12-300-003).
5. Close-up
Subtask 55-20-00-081-055-A
A. Remove Locking Devices
   (1) Remove the 98D27903500000 PIN-SIDE STICK LOCKING from the CAPT and F/O side stick controllers.
CAUTION: MAKE SURE THAT YOU REMOVE THE "COLLAR-ELEVATOR SERVO CONTROL SAFETY" BEFORE YOU PRESSURIZE THE ELEVATOR SERVO CONTROL. IF YOU DO NOT REMOVE THE COLLAR, YOU CAN CAUSE DAMAGE TO THE ELEVATOR SERVO CONTROL.
   (2) Remove the 98D27309009003 COLLAR-DEPTH ACTUATOR or 98D27309009004 COLLAR-DEPTH ACTUATOR from the servocontrol elevators.
Subtask 55-20-00-942-055-A
B. Remove Ground Equipment
   (1) Remove the ground support and maintenance equipment, the special and standard tools and all other items.
   (2) Remove the access platform(s).
   (3) Remove the WARNING NOTICE(S).
Subtask 55-20-00-865-065-A
C. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/ELAC1/NORM/SPLY15CE1B11
49VUFLIGHT CONTROLS/THS/ACTR/MOT219CE2B09
49VUFLIGHT CONTROLS/SEC1/NORM/SPLY21CE1B08
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/ELAC1/NORM/SPLY15CE1B06
49VUFLIGHT CONTROLS/THS/ACTR/MOT219CE2B04
49VUFLIGHT CONTROLS/SEC1/NORM/SPLY21CE1B03
** ON A/C ALL
105VUFLIGHT CONTROLS/ELAC2/STBY SPLY16CE2A02
105VUFLT CTL/ELAC1/STBY SPLY16CE1A01
105VUFLT CTL/SEC1/STBY SPLY22CEB01
121VUFLIGHT CONTROLS/SEC3/SPLY21CE3Q19
121VUFLIGHT CONTROLS/SEC2/SPLY21CE2Q18
121VUFLIGHT CONTROLS/THS ACTR/MOT319CE3Q17
121VUFLIGHT CONTROLS/THS ACTR/MOT119CE1Q16
121VUFLIGHT CONTROLS/ELAC2/NORM/SPLY15CE2R20
[Rev.10 from 2021] 2026.04.01 02:05:28 UTC
"Aviabrain" 2025