W DOC AIRBUS | AMM A320F

Removal of Trimmable Horizontal Stabilizer (THS) Tips 332AB/342AB

TASK 55-14-11-000-001-A
Removal of Trimmable Horizontal Stabilizer (THS) Tips 332AB/342AB

WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS SURFACES ARE CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.
WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS SURFACES ARE CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.
WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
  • THE FLIGHT CONTROLS
  • THE FLIGHT CONTROL SURFACES
  • THE LANDING GEAR AND THE RELATED DOORS
  • COMPONENTS THAT MOVE.
MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.
WARNING: YOU MUST PUT ON AND ATTACH A SAFETY HARNESS BEFORE YOU START WORK:
  • ON THE THS OR IN THE REAR FUSELAGE
  • ON TOP OF THE WINGS OR PYLONS.
WITHOUT A SAFETY HARNESS, YOU CAN FALL. THIS CAN KILL YOU OR CAUSE YOU INJURY.
WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.
CAUTION: DO NOT CAUSE DAMAGE TO THE SURFACES. THE COMPONENTS ARE MADE OF CARBONFIBER REINFORCED PLASTIC.
ZONE: 332
ZONE: 342
1. Reason for the Job
Self explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
ACCESS PLATFORM 4M (13 FT)
No specific
AR
SAFETY CLIP - CIRCUIT BREAKER
No specific
AR
WARNING NOTICE(S)
98D27903500000
2
PIN-SIDE STICK LOCKING
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
332
THS TIP
342
THS TIP
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 23-61-41-000-001-A
Removal of the Static Discharger
TASK 29-10-00-864-001-A
Depressurize the Green Hydraulic System
TASK 29-10-00-864-002-A
Depressurize the Yellow Hydraulic System
TASK 29-10-00-864-003-A
Depressurize the Blue Hydraulic System
F THS Tip
3. Job Set-up
Subtask 55-14-11-860-050-A
A. Depressurize Hydraulic Systems
   (1) Make sure that the Green, Yellow and Blue hydraulic systems are depressurized (Ref. AMM TASK 29-10-00-864-001), (Ref. AMM TASK 29-10-00-864-002) and (Ref. AMM TASK 29-10-00-864-003).
Subtask 55-14-11-865-050-A
B. Open, safety and tag this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/THS/ACTR/MOT219CE2B09
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/THS/ACTR/MOT219CE2B04
** ON A/C ALL
121VUFLIGHT CONTROLS/THS ACTR/MOT319CE3Q17
121VUFLIGHT CONTROLS/THS ACTR/MOT119CE1Q16
Subtask 55-14-11-481-050-A
C. Install Locking Devices
   (1) Put the 98D27903500000 PIN-SIDE STICK LOCKING in the CAPT and F/O side stick controllers.
Subtask 55-14-11-941-050-A
D. Safety Precautions
   (1) Put the WARNING NOTICE(S) in the flight compartment to tell persons not to operate the flight controls.
   (2) Put the WARNING NOTICE(S) in position to tell persons not to operate the hydraulic systems.
   (3) Put the ACCESS PLATFORM 4M (13 FT) in position at zone 332 for the left hand tip and/or zone 342 for the right hand tip.
4. Procedure
Subtask 55-14-11-020-050-A
A. Removal of the Tip
NOTE: The removal of the left tip 332AB is shown. The removal of the right tip 342AB is the same.
   (1) Remove the static discharger (Ref. AMM TASK 23-61-41-000-001).
   (2) Remove the screws (1).
   (3) Remove the tip (2).
[Rev.10 from 2021] 2026.04.01 03:50:23 UTC
"Aviabrain" 2025