Preparation for Installation

TASK 55-13-11-560-001-A
Preparation for Installation

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: YOU MUST PUT ON AND ATTACH A SAFETY HARNESS BEFORE YOU START WORK:

ON THE THS OR IN THE REAR FUSELAGE
ON TOP OF THE WINGS OR PYLONS.

WITHOUT A SAFETY HARNESS, YOU CAN FALL. THIS CAN KILL YOU OR CAUSE YOU INJURY.

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

CAUTION: DO NOT CAUSE DAMAGE TO THE SURFACES. THE COMPONENTS ARE MADE OF CARBONFIBER REINFORCED PLASTIC.

CAUTION: USE ONLY THE SPECIFIED MATERIALS AND OBEY THE INSTRUCTIONS FROM THE MATERIAL MANUFACTURERS. OTHER MATERIALS CAN CAUSE DAMAGE TO THE SURFACE PROTECTION OF THE COMPONENTS AND THE RELATED AREA.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SCRAPER - NON METALLIC
98D27903500000	2	PIN-SIDE STICK LOCKING

B. Consumable Materials

REFERENCE	DESIGNATION
(Material No.08BAA9)	Non Aqueous Cleaner-General - -

C. Referenced Information

REFERENCE	DESIGNATION
TASK 29-10-00-864-001-A	Depressurize the Green Hydraulic System
TASK 29-10-00-864-002-A	Depressurize the Yellow Hydraulic System
TASK 29-10-00-864-003-A	Depressurize the Blue Hydraulic System
THS Trailing Edge

3. Job Set-up
Subtask 55-13-11-860-051-A

A. Aircraft Maintenance Configuration
(1) Make sure that the hydraulic systems are depressurized (Ref. AMM TASK 29-10-00-864-001), (Ref. AMM TASK 29-10-00-864-002), (Ref. AMM TASK 29-10-00-864-003):
(2) Make sure that the 98D27903500000 PIN-SIDE STICK LOCKING is in the CAPT and F/O side stick controllers.
(3) Make sure that the warning notices are in the flight compartment to tell persons not to operate the flight controls.
(4) Make sure that the warning notices are in position to tell persons not to operate the hydraulic systems.
(5) Make sure that the access platforms are in position at zone 334 and/or zone 344.

4. Procedure
Subtask 55-13-11-140-050-A

A. Cleaning
(1) Remove the old sealant from the mating surfaces of the panels. Use a SCRAPER - NON METALLIC.
(2) Remove the old sealant around the anchor nuts of the ribs. Use a SCRAPER - NON METALLIC.

Subtask 55-13-11-110-050-A

B. Cleaning
(1) Clean the mating surfaces with Non Aqueous Cleaner-General - - (Material No.08BAA9)

Subtask 55-13-11-210-050-A

C. Visual Inspection
(1) Make sure that the anchor nuts and the sealing strips are in a good condition.

[Rev.10 from 2021] 2026.04.01 02:04:52 UTC