Installation of the Maintenance Panels at Frame 35.5

TASK 53-22-14-400-002-A
Installation of the Maintenance Panels at Frame 35.5

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	Torque wrench: range to between 0.42 and 0.37 m.daN (37.17 and 32.74 lbf.in )

B. Consumable Materials

REFERENCE	DESIGNATION
(Material No.05TBB9)	Adhesive Tape-Slip Resistant Resilient Legacy
(Material No.08BAA9)	Non Aqueous Cleaner-General - -
(Material No.14SBA1)	Textile-Lint free Cotton -

C. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
131NW, 131UW, 132PW

D. Referenced Information

REFERENCE	DESIGNATION
TASK 25-54-12-400-001-A	Installation of the Forward Cargo-Compartment Partition
TASK 52-30-00-860-002-A	Close the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump
Maintenance Panels at Frame 35.5

3. Job Set-up
Subtask 53-22-14-860-051-A ** ON A/C NOT FOR ALL

A. Aircraft Maintenance Configuration
(1) Make sure that the aircraft is in the same configuration as for the removal task.

4. Procedure
Subtask 53-22-14-916-051-A ** ON A/C NOT FOR ALL

A. Preparation for Installation
(1) Apply Adhesive Tape-Slip Resistant Resilient Legacy (Material No.05TBB9) to the maintenance panels (1), if necessary.
(2) Clean the component interface and the adjacent area with Non Aqueous Cleaner-General - - (Material No.08BAA9) and a clean cloth Textile-Lint free Cotton - (Material No.14SBA1) .
(3) Make sure that the parts retained from the removed component are clean and in the correct condition.
(4) Do an inspection of the component interfaces and the adjacent area.

Subtask 53-22-14-420-051-A ** ON A/C NOT FOR ALL

B. Installation of the Maintenance Panels

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

(1) Make sure that the work area is clean and clear of tools and other items.
(2) Put the maintenance panels (1) in the installation position.
(3) Install the screws (2) with the countersunk washers (3).
(4) TORQUE the screws (2) to between 0.42 and 0.37 m.daN (37.17 and 32.74 lbf.in )

5. Close-up
Subtask 53-22-14-410-051-A ** ON A/C NOT FOR ALL

A. Close Access
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Install the fwd cargo-compartment partitions 131NW 131UW 132PW (Ref. AMM TASK 25-54-12-400-001).
(3) Close the fwd cargo-compartment door (Ref. AMM TASK 52-30-00-860-002).
(4) Remove the access platform(s).
(5) Remove the ground support and maintenance equipment, the special and standard tools and all other items.

[Rev.10 from 2021] 2026.04.01 03:46:30 UTC