DOC AIRBUS | AMM A320FRemoval of the Forward Cargo-Compartment Floor-Panels
TASK 53-22-14-000-001-A
Removal of the Forward Cargo-Compartment Floor-Panels
Self Explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
B. Referenced Information
3. Job Set-up
Subtask 53-22-14-010-050-A
Subtask 53-22-14-020-050-A
[Rev.10 from 2021]
2026.04.01 01:53:34 UTC
Removal of the Forward Cargo-Compartment Floor-Panels
NOTE: For the FINs of the forward cargo-compartment floor-panels, refer to DO 06-41-53-00.
1. Reason for the JobSelf Explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment
| REFERENCE | QTY | DESIGNATION |
|---|---|---|
| No specific | 1 | ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE |
| No specific | 1 | SCRAPER - NON METALLIC |
| No specific | 1 | SPATULA - NON METALLIC |
| REFERENCE | DESIGNATION |
|---|---|
| TASK 52-30-00-860-001-A | Open the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump |
Forward Cargo-Compartment Floor-PanelsSubtask 53-22-14-010-050-A
A. Get Access
(1) Open the forward cargo-compartment door (Ref. AMM TASK 52-30-00-860-001).
(2) Put the ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE in position below the forward cargo-compartment door.
4. Procedure(1) Open the forward cargo-compartment door (Ref. AMM TASK 52-30-00-860-001).
(2) Put the ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE in position below the forward cargo-compartment door.
Subtask 53-22-14-020-050-A
A. Removal of the Floor Panels
(2) Pull the cord (3) up to remove the sealant from between the floor panels (1).
(3) Remove the sealant from between the cutouts and the tiedown positions with a SCRAPER - NON METALLIC.
(4) Use a SPATULA - NON METALLIC for the removal of floor panels (1), if the cord (3) breaks.
(5) Remove the sealant from the nuts (9) with a SCRAPER - NON METALLIC.
(6) Remove the screws (2) and if installed, the washers (8) and the nuts (9).
NOTE: This procedure is applicable for all the floor panels.
(1) Find the end of the cord (3). (2) Pull the cord (3) up to remove the sealant from between the floor panels (1).
(3) Remove the sealant from between the cutouts and the tiedown positions with a SCRAPER - NON METALLIC.
(4) Use a SPATULA - NON METALLIC for the removal of floor panels (1), if the cord (3) breaks.
(5) Remove the sealant from the nuts (9) with a SCRAPER - NON METALLIC.
(6) Remove the screws (2) and if installed, the washers (8) and the nuts (9).
NOTE: Identify the length of the screws (2) and if installed, the position of the washers (8) and the nuts (9). This will help with the installation procedure.
(7) Remove the floor panels (1) and if it is installed, the seals (4), (5), (6) and (7). NOTE: Put identification on each floor panel. This will help with the installation procedure.