Removal of the Cabin Entrance Light Dimming Switch

TASK 33-21-12-000-001-A
Removal of the Cabin Entrance Light Dimming Switch

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CAP - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER

B. Referenced Information

REFERENCE	DESIGNATION
Cabin Entrance Light Dimming Switch

3. Job Set-up
Subtask 33-21-12-010-050-A

A. Get Access
(1) Open the cockpit door.

Subtask 33-21-12-865-050-A

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
2000VU	LIGHT-CABIN-ENTRY	308LG	J02

4. Procedure
Subtask 33-21-12-020-050-A

A. Removal of the Limit Switch 310LG

Cabin Entrance Light Dimming Switch

(1) Remove the screws (11) and the bracket (12) from the cockpit wall (1).
(2) Carefully remove the switch bracket (8) together with the limit switch (3) from the insert of the cockpit wall (1).
(3) Cut and remove the lockwire from the adjustment nut (6) and the lock nut (10).
(4) Remove the lock nut (10) and the serrated washer (9) from the limit switch (3).
(5) Remove the limit switch (3) together with the adjustment nut (6) and the lock washer (7) from the swtich bracket (3).
(6) Disconnect the wires of the cable harness (2) from the limit switch (3). Tag and identify each wire as it is disconnected.
(7) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.

[Rev.10 from 2021] 2026.04.01 00:53:21 UTC