Removal of the Brake Temperature Sensor

TASK 32-47-15-000-001-A
Removal of the Brake Temperature Sensor

ZONE: 731
ZONE: 741
FIN: 4GW
FIN: 5GW
FIN: 6GW
FIN: 7GW

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CAP - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
731	L.H MAIN GEAR
741	R.H MAIN GEAR

C. Referenced Information

REFERENCE	DESIGNATION
Brake Temperature Sensor

3. Job Set-up
Subtask 32-47-15-865-050-A

A. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
121VU	HYDRAULIC/BRK/TEMP/DET/UNIT	1GW	M37

Subtask 32-47-15-941-052-A

B. Safety Precautions
(1) Put the WARNING NOTICE(S) in the cockpit to tell persons not to operate the landing gears.

4. Procedure
Subtask 32-47-15-020-050-B

A. Removal of the Brake Temperature Sensor
(1) Fold the rubber sleeve (4) until you can disconnect the connector (3).
(2) Disconnect the connector (3) from the temperature sensor (1).
(3) Put a CAP - BLANKING on the connector (3).

WARNING: USE PROTECTIVE GOGGLES AND GLOVES WHEN YOU REMOVE OR INSTALL LOCKWIRE. EACH TIME YOU CUT LOCKWIRE, REMOVE AND DISCARD IT IMMEDIATELY. LOOSE LOCKWIRE CAN CUT YOU OR MAKE YOU BLIND, AND/OR CAN CAUSE DAMAGE.

(4) Cut and remove the lockwire from the screw (2) and discard it.
(5) Remove the screw (2).
(6) Release the temperature sensor (1) from its housing along its axis.
(7) Put the protective cap (5) on the temperature sensor (1).

[Rev.10 from 2021] 2026.04.01 04:26:06 UTC