Brake Temperature Sensor Reactivation

TASK 32-47-00-440-001-A
Brake Temperature Sensor Reactivation

1. Reason for the Job
MMEL 32-07-01B
BRAKES TEMPERATURE INDICATION ON THE WHEEL SD PAGE
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	WARNING NOTICE(S)

B. Referenced Information

REFERENCE	DESIGNATION
Brake Temperature Sensor Deactivation/Reactivation

3. Job Set-up
Subtask 32-47-00-941-051-A

A. Put a WARNING NOTICE(S) in position in the cockpit to tell persons not to operate the landing gear control lever and the brake pedals.

Subtask 32-47-00-865-052-A

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
121VU	HYDRAULIC/BRK/TEMP/DET/UNIT	1GW	M37
121VU	HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY	4GG	M36

4. Procedure
Subtask 32-47-00-440-050-A

A. Reactivation of the Brake Temperature Sensor
(1) Remove and discard the lockwire around the tape on the electrical connector (2).
(2) Remove the self-adhesive tape from the electrical connector (2).
(3) Remove the blanking caps from the two connectors.
(4) Connect the connector (2) to the temperature sensor (1).

Subtask 32-47-00-865-055-A

B. Remove the safety clip(s) and the tag(s) and close this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
121VU	HYDRAULIC/BRK/TEMP/DET/UNIT	1GW	M37
121VU	HYDRAULIC/BRAKING AND STEERING/SYS2/SPLY	4GG	M36

5. Close-up
Subtask 32-47-00-942-050-A

A. Remove the warning notice(s) and the temporary placards from the cockpit.

[Rev.10 from 2021] 2026.04.01 00:50:20 UTC