Nose Wheel Hubcap Reactivation

TASK 32-41-00-440-001-A
Nose Wheel Hubcap Reactivation

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

1. Reason for the Job
CDL 32-03
Nose Wheel Hubcap
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CHOCK - WHEEL(S)
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	WARNING NOTICE(S)
No specific	Torque wrench: range to between 0.51 and 0.4 m.daN (45.13 and 35.40 lbf.in )

B. Consumable Materials

REFERENCE	DESIGNATION
(Material No.06LCG9)	Non Hardening Jointing Putty-Medium Temp. Area - -

C. Referenced Information

REFERENCE	DESIGNATION
Nose Wheel Hubcap Deactivation/Reactivation

3. Job Set-up
Subtask 32-41-00-941-053-A

A. Safety Precautions
(1) On the panel 400VU:

put a WARNING NOTICE(S) in position to tell persons not to operate the landing gear control lever.

(2) Install the CHOCK - WHEEL(S) at the main landing gear.

4. Procedure
Subtask 32-41-00-440-051-A

A. Reactivation of the Nose Wheel Hubcap
(1) Install the hubcap (1).
(2) Apply a thin layer of Non Hardening Jointing Putty-Medium Temp. Area - - (Material No.06LCG9) to the screws (2).
(3) Install the washers (3) and the screws (2).
(4) Torque the screws (2) to between 0.51 and 0.4 m.daN (45.13 and 35.40 lbf.in )

5. Close-up
Subtask 32-41-00-942-053-A

A. Removal of Equipment
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Remove the WARNING NOTICE(S).
(3) Remove the CHOCK - WHEEL(S) at the main landing gear.

[Rev.10 from 2021] 2026.04.01 00:47:01 UTC