Nose Wheel Hubcap Deactivation

TASK 32-41-00-040-001-A
Nose Wheel Hubcap Deactivation

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

1. Reason for the Job
CDL 32-03
Nose Wheel Hubcap
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CHOCK - WHEEL(S)
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	WARNING NOTICE(S)

B. Referenced Information

REFERENCE	DESIGNATION
Nose Wheel Hubcap Deactivation/Reactivation

3. Job Set-up
Subtask 32-41-00-941-052-A

A. Safety Precautions
(1) On the panel 400VU:

put a WARNING NOTICE(S) in position to tell persons not to operate the landing gear control lever.

(2) Install the CHOCK - WHEEL(S) at the main landing gear.

4. Procedure
Subtask 32-41-00-040-051-A

A. Deactivation of the Nose Wheel Hubcap
(1) Remove the screws (2) and the washers (3).
(2) Remove the hubcap (1).

5. Close-up
Subtask 32-41-00-942-052-A

A. Remove the safety devices:
(1) Remove the warning notice from the cockpit.
(2) Remove the wheel chocks at the main landing gear.
(3) Make an entry in the logbook.

[Rev.10 from 2021] 2026.04.01 00:47:00 UTC