W DOC AIRBUS | AMM A320F

Detailed Inspection of the External Surfaces of the Upper and Lower Torque Links of the Nose Landing Gear

TASK 32-21-00-200-013-A
Detailed Inspection of the External Surfaces of the Upper and Lower Torque Links of the Nose Landing Gear

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.
WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE LANDING GEAR ARE CLEAR.
ZONE: 710
1. Reason for the Job
Refer to the MPD TASK: 322142-01
DETAILED INSPECTION OF NOSE LANDING GEAR, TORQUE LINKS - EXTERNAL SURFACES, EXCEPT WHERE COVERED BY DRESSINGS AND BUSH FLANGES.
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
CHOCK - WHEEL(S)
No specific
1
SAFETY BARRIER(S)
No specific
1
WARNING NOTICE(S)
D23080000
1
PIN-GROUND LOCK,NLG
MZ23080000
1
PIN-LOCKING
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
710
NOSE GEAR AND DOORS
 C. Referenced Information
REFERENCE
DESIGNATION
F External Surfaces of the Torque Links of the Nose Landing Gear
3. Job Set-up
Subtask 32-21-00-941-078-A
A. Safety Precautions
   (1) Make sure that the D23080000 PIN-GROUND LOCK,NLG or MZ23080000 PIN-LOCKING, as an alternative, is in position.
   (2) In the cockpit, on the right center instrument panel 400VU:
  • Put a WARNING NOTICE(S) in position to tell persons not to operate the landing-gear normal control-lever.
   (3) On the steering handwheels (CAPT and F/O) and on the brake pedals:
  • Put a WARNING NOTICE(S) in position to tell persons not to operate them.
   (4) Put SAFETY BARRIER(S) in position.
Subtask 32-21-00-860-081-A
B. Aircraft Maintenance Configuration
   (1) On the right center instrument panel 400VU:
  • Make sure that the landing-gear normal control-lever is in the DOWN position.
   (2) On the rudder/trim parking-brake panel 110VU:
  • Make sure that the free-fall control handle is in the usual position.
   (3) Make sure that CHOCK - WHEEL(S) are in position on the main landing gear.
4. Procedure
Subtask 32-21-00-220-062-A
A. Detailed Inspection of the External Surfaces of the Upper and Lower Torque Links of the Nose Landing Gear
   (1) Do a detailed visual inspection of the torque links external surfaces and look for signs of:
  • Damage to the protective finish
  • Dents and scratches
  • Corrosion.
NOTE: If necessary, refer to the applicable CMM procedure for the correct repair.
5. Close-up
Subtask 32-21-00-860-082-A
A. Put the aircraft back to its initial configuration.
   (1) Remove the WARNING NOTICE(S).
   (2) Remove the safety barriers.
   (3) Make sure that the work area is clean and clear of tools and other items.
[Rev.10 from 2021] 2026.04.01 00:41:44 UTC
"Aviabrain" 2025