Installation of the Collector Tanks of the Seal Drain System

TASK 29-17-11-400-001-A
Installation of the Collector Tanks of the Seal Drain System

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	CONTAINER - HYDRAULIC FLUID RESISTANT

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
196BB

C. Referenced Information

REFERENCE	DESIGNATION
TASK 29-00-00-910-002-A	Safety Procedures of the Hydraulic System
TASK 32-12-00-010-001-A	Open the Main Gear Doors for Access
TASK 32-12-00-410-001-A	Close the Main Gear Doors after Access
Collector Tank

3. Job Set-up
Subtask 29-17-11-860-050-A

A. Aircraft Maintenance Configuration

WARNING: OBEY THE HYDRAULIC SAFETY PROCEDURES.

(1) Obey the hydraulic safety procedures (Ref. AMM TASK 29-00-00-910-002).
(2) Make sure that the access door 196BB is open.
(3) Make sure that the right main door of the main gear is open (Ref. AMM TASK 32-12-00-010-001).
(4) Make sure that the CONTAINER - HYDRAULIC FLUID RESISTANT is in position below the location of the collector tank.

4. Procedure
Subtask 29-17-11-420-050-A

A. Installation of the Collector Tank
(1) Clean the component interfaces and the adjacent area.
(2) Do an inspection of the component interfaces and the adjacent area.
(3) Remove the blanking plugs.
(4) Put the collector tank (3) in position.
(5) Engage and close the clamp (2).
(6) Make sure that the hydraulic line end-fittings are serviceable.
(7) Connect the pipe end-fitting (1) to the collector tank (3).

5. Close-up
Subtask 29-17-11-942-050-A

A. Remove the container.

Subtask 29-17-11-410-050-A

B. Close Access
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Close the right main door of the main gear (Ref. AMM TASK 32-12-00-410-001).
(3) Close the access door 196BB.

[Rev.10 from 2021] 2026.04.01 00:25:29 UTC