Drain the Water Separator

TASK 29-14-00-680-001-A
Drain the Water Separator

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS SURFACES ARE CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.

ZONE: 195

1. Reason for the Job
Refer to the MPD TASK: 291000-05
DRAIN WATER SEPARATOR
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	CONTAINER 1 L (1/4 USGAL)
No specific	1	HOSE - PLASTIC

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
195	HYDRAULIC COMPT AND FAIRINGS
195BB

C. Referenced Information

REFERENCE	DESIGNATION
Draining of the Fluid Separator

3. Job Set-up
Subtask 29-14-00-010-060-A

A. Open the access panel 195BB.

4. Procedure
Subtask 29-14-00-680-050-B

A. Draining
(1) Put the CONTAINER 1 L (1/4 USGAL) in position below the reservoir pressurization unit.
(2) Connect the HOSE - PLASTIC to the drain connection.
(3) Push the drain valve in and drain all of the fluid into the container.
(4) Release the drain valve.
(5) Disconnect the HOSE - PLASTIC from the drain connection.

5. Close-up
Subtask 29-14-00-410-059-A

A. Close Access
(1) Remove the container.
(2) Make sure that the work area is clean and clear of tools and other items.
(3) Close the access panel 195BB.

[Rev.10 from 2021] 2026.04.01 00:24:09 UTC