W DOC AIRBUS | AMM A320F

Removal of the Lighted Plate

TASK 27-51-43-000-002-A
Removal of the Lighted Plate

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
  • THE FLIGHT CONTROLS
  • THE FLIGHT CONTROL SURFACES
  • THE LANDING GEAR AND THE RELATED DOORS
  • COMPONENTS THAT MOVE.
MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.
ZONE: 210
1. Reason for the Job
Self Explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
SAFETY CLIP - CIRCUIT BREAKER
 B. Work Zones and Access Panels
ZONE/ACCESS
ZONE DESCRIPTION
210
CKPT,FWD COMPT BHD TO FLT COMPT BULKHEAD
 C. Referenced Information
REFERENCE
DESIGNATION
TASK 27-50-00-866-009-A
Retraction of the Flaps on the Ground
TASK 27-50-00-866-009-A-01
Retraction of the Flaps/Slats on the Ground
F Lighted Plate of the Flaps and Slats Control Lever
3. Job Set-up
Subtask 27-51-43-860-053-A
A. Aircraft Maintenance Configuration
   (1) Make sure that the flaps and slats are in the fully retracted position (Ref. AMM TASK 27-50-00-866-009).
   (2) Make sure that the hydraulic systems are depressurized.
Subtask 27-51-43-865-053-A
B. Open, safety and tag this(these) circuit breaker(s):
PANELDESIGNATIONFINLOCATION
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/SLT FLP/POS/IND 11CNB12
49VUFLIGHT CONTROLS/FLP/CTL AND MONG/SYS16CVB07
49VUFLIGHT CONTROLS/SLT/CTL AND MONG/SYS15CVB06
** ON A/C NOT FOR ALL
49VUFLIGHT CONTROLS/SLT FLP/POS/IND 11CNB07
49VUFLIGHT CONTROLS/FLP/CTL AND MONG/SYS16CVB02
49VUFLIGHT CONTROLS/SLT/CTL AND MONG/SYS15CVB01
** ON A/C NOT FOR ALL
121VUFLIGHT CONTROLS/SLT FLP/2POS/IND2CNP16
** ON A/C ALL
121VUFLIGHT CONTROLS/WTB/FLP/SYS212CVP20
121VUFLIGHT CONTROLS/WTB/SLT/SYS211CVP19
121VUFLIGHT CONTROLS/FLP/CTL AND/MONG/SYS28CVQ21
121VUFLIGHT CONTROLS/SLT/CTL/SYS27CVR21
** ON A/C NOT FOR ALL
121VUFLIGHT CONTROLS/SLT FLP/2POS/IND2CNP21
** ON A/C ALL
122VUFLIGHT CONTROLS/WTB/FLP/SYS110CVS07
122VUFLIGHT CONTROLS/WTB/SLT/SYS19CVS06
122VULIGHTING/INSTL LT/MAIN INST/PNL AND/PED4LFY04
4. Procedure
Subtask 27-51-43-020-052-A
A. Removal of the Lighted Plate
   (1) Remove the screw (13) and the handle (12).
   (2) Remove the set screw (14).
   (3) Remove and discard the pin (16).
   (4) Remove the index (15).
   (5) Remove the screws (11).
   (6) Remove the lighted plate (20).
[Rev.10 from 2021] 2026.04.01 12:32:46 UTC
"Aviabrain" 2025