W DOC AIRBUS | AMM A320F

Removal of the Inboard and Outboard Flap Hoisting-Sling

TASK 27-50-00-000-002-A
Removal of the Inboard and Outboard Flap Hoisting-Sling

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
  • THE FLIGHT CONTROLS
  • THE FLIGHT CONTROL SURFACES
  • THE LANDING GEAR AND THE RELATED DOORS
  • COMPONENTS THAT MOVE.
MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.
1. Reason for the Job
Self Explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
1
HOIST 250 KG (551 LB), 6 M (19,7 FT) - LIFT
No specific
AR
SAFETY BARRIER(S)
No specific
AR
WARNING NOTICE(S)
98F27508498000
1
HOIST-R I,FLAP SLAT
 B. Referenced Information
REFERENCE
DESIGNATION
F Hoisting Sling Details
3. Job Set-up
Subtask 27-50-00-941-057-A
A. Safety Precautions
   (1) Make sure that the SAFETY BARRIER(S) are in position.
   (2) Make sure that the WARNING NOTICE(S) is in position to tell persons not to operate the flap/slat control lever.
4. Procedure
Subtask 27-50-00-080-051-B
A. Removal of the Inboard Flap Hoisting Sling
   (1) Remove the pip-pins (11) and disconnect the hoisting sling from the inboard flap.
   (2) Remove the lifting-lugs (12) from the inboard flap and connect them to the hoisting sling with the pip-pins (11).
   (3) Remove the 98F27508498000 HOIST-R I,FLAP SLAT from the HOIST 250 KG (551 LB), 6 M (19,7 FT) - LIFT.
   (4) Install the blanking caps in the flap. Make sure that the top of the blanking caps is not above the surface of the flap.
   (5) Install the protective caps (14) to the lifting-lugs (12) of the hoisting sling.
Subtask 27-50-00-080-052-B
B. Removal of the Outboard Flap Hoisting Sling
   (1) Remove the pip-pins (11) and disconnect the hoisting sling from the outboard flap.
   (2) Remove the lifting-lugs (12) from the outboard flap and connect them to the hoisting sling with the pip-pins (11).
   (3) Remove the 98F27508498000 HOIST-R I,FLAP SLAT from the HOIST 250 KG (551 LB), 6 M (19,7 FT) - LIFT.
   (4) Install the blanking caps in the flap. Make sure that the top of the blanking caps is not above the surface of the flap.
   (5) Install the protective caps (14) to the lifting-lugs (12) of the hoisting sling.
5. Close-up
Subtask 27-50-00-942-058-A
A. Removal of Equipment
   (1) Make sure that the work area is clean and clear of tools and other items.
   (2) Remove the safety barriers.
   (3) Remove the WARNING NOTICE(S).
   (4) Remove the ground support and maintenance equipment, the special and standard tools and all other items.
[Rev.10 from 2021] 2026.03.31 23:52:01 UTC
"Aviabrain" 2025