Bonding Point Temporary Protection

TASK 20-28-00-912-804-A
Bonding Point Temporary Protection

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

1. Reason for the Job
This procedure is applicable, when the bonding installation of the part or the equipment is not possible in 1 week or less after the removal.
2. Job Set-up Information
A. Consumable Materials

REFERENCE	DESIGNATION
(Material No.03GEE1)	Synthetic Oil base Grease-Fuel and Oxidized Environment Fluorinated -
(Material No.03HBD9)	Synthetic Ester base Grease-General Purpose Low Temp -

B. Referenced Information

REFERENCE	DESIGNATION
Bonding - Temporary Protection - Typical

3. Job Set-up
Subtask 20-28-00-941-066-A

A. There is no special job set-up for this task.

4. Procedure
Subtask 20-28-00-916-097-A

A. Temporary protection of the bare surface

Bonding - Temporary Protection - Typical

(1) Materials:

Synthetic Ester base Grease-General Purpose Low Temp - (Material No.03HBD9) on all the bare surfaces but do not apply Synthetic Ester base Grease-General Purpose Low Temp - (Material No.03HBD9) on the oxygen system circuits
Synthetic Oil base Grease-Fuel and Oxidized Environment Fluorinated - (Material No.03GEE1) on the oxygen circuits.

(2) Apply the temporary protection material on all the bare surface area and make an overlap of 2 mm (0.08 in.) around the bare surface limit.

[Rev.10 from 2021] 2026.04.01 04:50:35 UTC