Installation of the Clamp NSA935813 on Pipe

TASK 20-23-11-911-802-A
Installation of the Clamp NSA935813 on Pipe

1. Reason for the Job
This procedure is only applicable for the installation of a clamp with a two-part frame, NSA935813, with a cleft bush on the pipe.
2. Job Set-up Information
A. Referenced Information

REFERENCE	DESIGNATION
TASK 20-21-11-911-001-A	Tightening Torques for Standard Threaded Fasteners
TASK 20-23-11-917-002-A	Installation and Repair of Hydraulic Lines
Clamp NSA935813 Installation

3. Job Set-up
Subtask 20-23-11-410-056-A

A. Install the tube (Ref. AMM TASK 20-23-11-917-002).

4. Procedure
Subtask 20-23-11-420-058-A

A. Clamp Installation

Clamp NSA935813 Installation

(1) Install the cleft bush on the pipe.
(2) Install the first clamp part on the cleft bush.
Make sure that the end of the first clamp part does not go between the tube and the cleft bush.

NOTE: If the end of the first clamp part goes through the bush opening, the clamp will touch the tube and will cause damage to the pipe.

(3) Install the second part of the clamp on the first part.
(4) Tighten the fasteners (Ref. AMM TASK 20-21-11-911-001).

[Rev.10 from 2021] 2026.04.01 04:47:22 UTC