General Visual Inspection of Powerplants, Nacelles and Pylons

TASK 05-24-00-200-002-A
General Visual Inspection of Powerplants, Nacelles and Pylons

WARNING: MAKE SURE THAT THE SAFETY DEVICES AND THE WARNING NOTICES ARE IN POSITION BEFORE YOU START A TASK ON OR NEAR: - THE FLIGHT CONTROLS - THE FLIGHT CONTROL SURFACES - THE LANDING GEAR AND RELATED DOORS - THE CARGO DOORS - THE ENGINES - OTHER COMPONENTS THAT MOVE. MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.

ZONE: 400

1. Reason for the Job
Refer to the MPD TASK: ZL-400-02
GENERAL VISUAL INSPECTION OF POWERPLANTS, NACELLES AND PYLONS
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 2M (6 FT)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
400	POWER PLANT, NACELLES AND PYLONS

C. Referenced Information

REFERENCE	DESIGNATION
Powerplants, Nacelles and Pylons ** ON A/C NOT FOR ALL
Powerplants, Nacelles and Pylons ** ON A/C NOT FOR ALL
Powerplants, Nacelles and Pylons ** ON A/C NOT FOR ALL

3. Job Set-up
Subtask 05-24-00-010-051-A

A. Get Access
(1) Put the ACCESS PLATFORM 2M (6 FT) in position at zone 400.

WARNING: BEFORE YOU START WORK, YOU MUST PUT ON A SAFETY HARNESS AND ATTACH IT TO THE ACCESS PLATFORM. WITHOUT A SAFETY HARNESS, YOU CAN FALL. THIS CAN KILL YOU OR CAUSE YOU INJURY.

(2) Put on and attach a safety harness before you start work in the work area.

4. Procedure
Subtask 05-24-00-210-051-A

A. Inspection

Powerplants, Nacelles and Pylons ** ON A/C NOT FOR ALL

(1) Do a general visual inspection of the powerplants, the nacelles and the pylons (zone 400).
(2) Make sure that there is no deterioration (damage, corrosion, leakage, cracks or chafing).

5. Close-up
Subtask 05-24-00-410-051-A

A. Close Access
(1) Remove the access platform(s).
(2) Remove all the fixtures, tools, test and support equipment used during this procedure.

[Rev.10 from 2021] 2026.03.31 22:49:48 UTC