General Visual Inspection of Stabilizers and Cone/Rear Fuselage

TASK 05-23-00-200-002-A
General Visual Inspection of Stabilizers and Cone/Rear Fuselage

ZONE: 300

1. Reason for the Job
Refer to the MPD TASK: ZL-300-02
GENERAL VISUAL INSPECTION OF STABILIZERS AND CONE/REAR FUSELAGE

NOTE: This is an alternative method for the general visual inspection of the stabilizers and the cone/rear fuselage.
For the other method, refer to the relevant task in this page block.

2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 12M (40 FT) - ADJUSTABLE

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
300	STABILIZERS AND TAIL UNIT

C. Referenced Information

REFERENCE	DESIGNATION
Inspection of the Stabilizers and the Cone/Rear Fuselage

3. Job Set-up
Subtask 05-23-00-010-050-A

A. Get Access
(1) Put the ACCESS PLATFORM 12M (40 FT) - ADJUSTABLE in position at zone 300.

4. Procedure
Subtask 05-23-00-210-051-A

A. Inspection

Inspection of the Stabilizers and the Cone/Rear Fuselage

(1) Do a general visual inspection of the stabilizers and cone/rear fuselage.
(2) Make sure that there are no signs of corrosion, cracks or damage.

5. Close-up
Subtask 05-23-00-410-050-A

A. Close Access
(1) Remove the access platform(s).

[Rev.10 from 2021] 2026.03.31 22:49:25 UTC