Reactivation of Starter Valve Manual Control [IAE]

TASK 80-11-00-440-043-A
Reactivation of Starter Valve Manual Control

FIN: 1000EM1 ** ON A/C NOT FOR ALL
FIN: 1000EM2 ** ON A/C NOT FOR ALL

1. Reason for the Job
MMEL 80-11-01A
START VALVE
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	WARNING NOTICE(S)

B. Referenced Information

REFERENCE	DESIGNATION
TSM 80-00-00-810-801	Failure of the Pneumatic Starter Valve on Engine 1
TSM 80-00-00-810-802	Failure of the Pneumatic Starter Valve on Engine 2

3. Job Set-up
Subtask 80-11-00-941-056-A ** ON A/C NOT FOR ALL

A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a WARNING NOTICE(S) to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a WARNING NOTICE(S) to tell persons not to energize the FADEC 1(2).

4. Procedure
Subtask 80-11-00-810-055-A ** ON A/C NOT FOR ALL

A. Do the trouble shooting of the pneumatic starter valve system TSM 80-00-00-810-801 or TSM 80-00-00-810-802.

5. Close-up
Subtask 80-11-00-869-054-A ** ON A/C NOT FOR ALL

A. Make sure that the work area is clean and clear of tools and other items.

Subtask 80-11-00-942-055-A ** ON A/C NOT FOR ALL

B. Remove the WARNING NOTICE(S).

[Rev.10 from 2021] 2026.04.01 03:44:43 UTC