Oil Quantity Indication - Quantity Check [IAE]

TASK 79-31-00-040-041-A
Oil Quantity Indication - Quantity Check

FIN: 1000EM1 ** ON A/C NOT FOR ALL
FIN: 1000EM2 ** ON A/C NOT FOR ALL

1. Reason for the Job
MMEL 79-07-03A
OIL QUANTITY INDICATION ON THE ENGINE SD PAGE
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	WARNING NOTICE(S)

B. Referenced Information

REFERENCE	DESIGNATION
TASK 12-13-79-610-011-A	Check Oil Level and Replenish

3. Job Set-up
Subtask 79-31-00-941-054-A ** ON A/C NOT FOR ALL

A. Safety Precautions
(1) On the center pedestal, on the ENG panel 115VU:
(a) Put a WARNING NOTICE(S) to tell persons not to start the engine.
(2) Make sure that the engine 1(2) shutdown occurred not less than 5 minutes before you do this procedure.
(3) On the overhead maintenance panel 50VU:
(a) Make sure that the ON legend of the ENG/FADEC GND PWR/1(2) pushbutton switch is off.
(b) Put a WARNING NOTICE(S) to tell persons not to energize the FADEC 1(2).

4. Procedure
Subtask 79-31-00-210-052-A ** ON A/C NOT FOR ALL

A. Make sure that there is no evidence of oil leakage at the equipment, lines and connections.
(1) Do a check of the oil level in the tank and fill it to the correct level if necessary (Ref. AMM TASK 12-13-79-610-011).

5. Close-up
Subtask 79-31-00-941-055-A ** ON A/C NOT FOR ALL

A. Put a WARNING NOTICE(S) in the cockpit to tell persons that the oil quantity indication does not operate.
(1) Do an entry in the log book.

[Rev.10 from 2021] 2026.04.02 06:39:55 UTC