W DOC AIRBUS | AMM A320F

Removal of the Secondary-Hinged-Fairing Attachment

TASK 57-26-21-000-001-A
Removal of the Secondary-Hinged-Fairing Attachment

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:
  • THE FLIGHT CONTROLS
  • THE FLIGHT CONTROL SURFACES
  • THE LANDING GEAR AND THE RELATED DOORS
  • COMPONENTS THAT MOVE.
MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.
WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.
1. Reason for the Job
Self explanatory
2. Job Set-up Information
 A. Fixtures, Tools, Test and Support Equipment
REFERENCE
QTY
DESIGNATION
No specific
AR
ACCESS PLATFORM 3M (10 FT)
No specific
AR
SAFETY BARRIER(S)
No specific
AR
WARNING NOTICE(S)
 B. Referenced Information
REFERENCE
DESIGNATION
TASK 32-00-00-481-001-A
Installation of the Safety Devices on the Landing Gears
TASK 32-00-00-481-002-A
Installation of the Safety Devices on the Landing Gear Doors
TASK 32-12-13-000-001-A
Removal of the Secondary Hinged Fairing
F Secondary Hinged-Fairing Attachment - Location and Detail
3. Job Set-up
Subtask 57-26-21-941-051-A
A. Safety Precautions
   (1) Install the safety devices on the landing gear (Ref. AMM TASK 32-00-00-481-001) and the landing gear doors (Ref. AMM TASK 32-00-00-481-002).
   (2) As necessary, use the applicable SAFETY BARRIERS, specified by the operator's instructions and your local regulations.
   (3) Put a WARNING NOTICE(S) in the cockpit, to tell persons not to operate:
  • the landing gear
  • the landing gear doors.
   (4) Put an ACCESS PLATFORM 3M (10 FT) below the applicable MLG secondary-hinged-fairing, zone 733 (743).
Subtask 57-26-21-010-051-A
B. Get Access
   (1) Remove the secondary-hinged-fairing (Ref. AMM TASK 32-12-13-000-001).
4. Procedure
Subtask 57-26-21-020-050-A
A. Removal of the Fairing Attachment
   (1) Remove and discard the cotter pin (9).
   (2) Remove the nut (8), the washer (7) and the bolt (6) and disconnect the actuating rod.
   (3) Remove and discard the cotter pin (1).
   (4) Remove the nut (2) and the washer (3).
   (5) Hold the secondary-hinged-fairing attachment (5) and remove the hinge pin (4). Remove the secondary-hinged-fairing attachment (5).
[Rev.10 from 2021] 2026.04.01 02:11:46 UTC
"Aviabrain" 2025