General Visual Inspection of AFT Emergency Exit Skin Cutouts, Upper and Lower Corners, External Surface, LH/RH

TASK 53-41-00-210-826-A
General Visual Inspection of AFT Emergency Exit Skin Cutouts, Upper and Lower Corners, External Surface, LH/RH

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: MAKE SURE THAT THE TRAVEL RANGES OF THE FLIGHT CONTROLS SURFACES ARE CLEAR. MOVEMENT OF FLIGHT CONTROLS CAN CAUSE INJURY TO PERSONS AND/OR DAMAGE TO EQUIPMENT.

WARNING: YOU MUST PUT ON AND ATTACH A SAFETY HARNESS BEFORE YOU START WORK:

ON THE THS OR IN THE REAR FUSELAGE
ON TOP OF THE WINGS OR PYLONS.

WITHOUT A SAFETY HARNESS, YOU CAN FALL. THIS CAN KILL YOU OR CAUSE YOU INJURY.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 5M (16 FT)- ADJUSTABLE
No specific	1	WARNING NOTICE(S)

B. Consumable Materials

REFERENCE	DESIGNATION
(Material No.08BAA9)	Non Aqueous Cleaner-General - -
(Material No.14SBA1)	Textile-Lint free Cotton -

C. Referenced Information

REFERENCE	DESIGNATION
SRM 53411101	(for corrective action)
SRM 53411102	(for corrective action)
Upper and Lower Corners of the AFT Emergency Skin Cutouts

3. Job Set-up
Subtask 53-41-00-941-082-A ** ON A/C NOT FOR ALL

A. Install the ground support equipment.
(1) Put a WARNING NOTICE(S) in position to tell persons not to operate the flight controls.
(2) Put the ACCESS PLATFORM 5M (16 FT)- ADJUSTABLE in the required position.

Subtask 53-41-00-110-109-A ** ON A/C NOT FOR ALL

B. Cleaning Procedure

WARNING: BE CAREFUL WHEN YOU USE CONSUMABLE MATERIALS. OBEY THE MATERIAL MANUFACTURER'S INSTRUCTIONS AND YOUR LOCAL REGULATIONS.

(1) Clean the area with a lint-free cotton cloth Textile-Lint free Cotton - (Material No.14SBA1) and the Non Aqueous Cleaner-General - - (Material No.08BAA9) , and let the area dry.

4. Procedure
Subtask 53-41-00-210-128-A ** ON A/C NOT FOR ALL

A. Inspection
(1) Examine the following areas for scratches, dents and cracks:

the external surface of the the upper and lower skin cutouts of the AFT Emergency Exit, LH and RH.

NOTE: If necessary, refer to the ASRM SRM 53411101 for the allowable damage limits.

NOTE: If necessary, refer to the ASRM SRM 53411102 for the correct repair procedure.

5. Close-up
Subtask 53-41-00-942-103-A ** ON A/C NOT FOR ALL

A. Remove the ground support equipment.
(1) Make sure that the work area is clean and clear of tools and other items.
(2) Remove the WARNING NOTICE(S).
(3) Remove the access platform(s).

[Rev.10 from 2021] 2026.04.02 06:29:18 UTC