Removal of the Fairlead

TASK 53-36-11-000-801-A
Removal of the Fairlead

ZONE: 140
ZONE: 190

1. Reason for the Job
Self Explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	1	ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	1	WARNING NOTICE(S)

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
140	CENTER WING
190	BELLY FAIR, AIR CONDITIONING & HYD COMPT

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-41-00-861-002-A	Energize the Aircraft Electrical Circuits from the External Power
TASK 24-41-00-861-002-A-01	Energize the Aircraft Electrical Circuits from the APU
TASK 24-41-00-861-002-A-02	Energize the Aircraft Electrical Circuits from Engine 1(2)
TASK 29-10-00-864-001-A	Depressurize the Green Hydraulic System
TASK 29-10-00-864-002-A	Depressurize the Yellow Hydraulic System
TASK 29-10-00-864-003-A	Depressurize the Blue Hydraulic System
TASK 32-12-00-010-001-A	Open the Main Gear Doors for Access
Fairlead

3. Job Set-up
Subtask 53-36-11-861-050-A

A. Aircraft Maintenance Configuration
(1) Energize the aircraft electrical circuits
(Ref. AMM TASK 24-41-00-861-002).

Subtask 53-36-11-010-050-A

B. Get Access
(1) Open the MLG doors (Ref. AMM TASK 32-12-00-010-001).
(2) Depressurize the Green, Blue, Yellow hydraulic systems (Ref. AMM TASK 29-10-00-864-001), (Ref. AMM TASK 29-10-00-864-002) and (Ref. AMM TASK 29-10-00-864-003).
(3) Put the WARNING NOTICE(S) in position to tell persons not to operate the MLG.
(4) Put the ACCESS PLATFORM 3M (10 FT)- ADJUSTABLE in position.

Subtask 53-36-11-865-050-A

C. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
49VU	L/G/LGCIU/SYS1/NORM	1GA	C09
121VU	HYDRAULIC/LGCIU/SYS2	2GA	Q35
121VU	HYDRAULIC/LGCIU/SYS1/GRND SPLY	52GA	Q34

4. Procedure
Subtask 53-36-11-020-050-A

A. Removal of the Fairlead
(1) Remove the screws (5) and (6) and the washers (4) and (7).
(2) Remove the plate (3).
(3) Remove the fairlead (2) from the pressure plate (1).
(4) Identify each half of the fairlead (2).

NOTE: This will help for the subsequent installation procedure.

(5) If necessary, remove all the identification plates (8).

[Rev.10 from 2021] 2026.04.02 06:29:13 UTC