Removal of the Proximity Switches of the Aft Emergency Exits

TASK 52-73-11-000-004-B
Removal of the Proximity Switches of the Aft Emergency Exits

ZONE: 241
ZONE: 242
FIN: 6WN1 ** ON A/C NOT FOR ALL
FIN: 6WN2 ** ON A/C NOT FOR ALL

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	ACCESS PLATFORM 5M (16 FT)- ADJUSTABLE
No specific	AR	CAP - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
241	CENTER PASSENGER COMPARTMENT
242	CENTER PASSENGER COMPARTMENT
834, 844
FOR [6WN1] (PROX SW-HANDLE, L AFT EMER EXIT ESC SLIDE)
834CZ
FOR [6WN2] (PROX SW-HANDLE, R AFT EMER EXIT ESC SLIDE)
844CZ

C. Referenced Information

REFERENCE	DESIGNATION
TASK 24-42-00-861-001-A	Energize the Ground Service Network from the External Power
TASK 52-22-00-010-002-A	Opening of the Emergency Exit Doors from the Outside
TASK 52-22-00-860-003-A	Special Precaution before Maintenance on the Door Damper and Emergency Operation Cylinder
Proximity Switches (6WN1, 6WN2) of the Aft Emergency Exits
FOR [6WN1] (PROX SW-HANDLE, L AFT EMER EXIT ESC SLIDE)
TASK 25-23-47-000-013-A	Removal of the Door Linings of the RH FWD Emergency Exit Door at zone 251 or RH AFT at zone 252 or LH AFT at zone 232.
FOR [6WN2] (PROX SW-HANDLE, R AFT EMER EXIT ESC SLIDE)
TASK 25-23-47-000-013-A	Removal of the Door Linings of the RH FWD Emergency Exit Door at zone 251 or RH AFT at zone 252 or LH AFT at zone 232.

3. Job Set-up
Subtask 52-73-11-861-057-A ** ON A/C NOT FOR ALL

A. Energize the ground service network
(Ref. AMM TASK 24-42-00-861-001).

Subtask 52-73-11-865-068-A ** ON A/C NOT FOR ALL

B. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C NOT FOR ALL
121VU	EIS/SLIDES/ARM AND WARN/FLT	15WN	P11
121VU	EIS/SLIDES/ARM AND WARN/GND	13WN	P10
121VU	EIS/SDAC1 AND 2/DOOR/DET/PAX	48WV	P05

Subtask 52-73-11-010-055-A ** ON A/C NOT FOR ALL

C. Get Access

WARNING: STOP THE OPENING PROCEDURE IF THE RED WARNING LIGHT FLASHES. IF THE RED WARNING LIGHT FLASHES, REMAINING PRESSURE CAN CAUSE THE DOOR TO OPEN SUDDENLY AND CAN:

KILL OR CAUSE SERIOUS INJURY TO PERSONS
CAUSE DAMAGE TO THE AIRCRAFT.

(1) Put an ACCESS PLATFORM 5M (16 FT)- ADJUSTABLE in position at the applicable emergency exit 834 or 844.
(2) Open the applicable emergency exit 834 or 844 (Ref. AMM TASK 52-22-00-010-002).
(3) Obey the special precautions before you start work on the emergency exit (Ref. AMM TASK 52-22-00-860-003).

Subtask 52-73-11-010-063-A ** ON A/C NOT FOR ALL

D. Removal of the Lining Panel
(1) Remove the lining panel:
(a) FOR [6WN1] (PROX SW-HANDLE, L AFT EMER EXIT ESC SLIDE)
834CZ (Ref. AMM TASK 25-23-47-000-013).
(b) FOR [6WN2] (PROX SW-HANDLE, R AFT EMER EXIT ESC SLIDE)
844CZ (Ref. AMM TASK 25-23-47-000-013).
(2) Remove the insulation blanket.

4. Procedure
Subtask 52-73-11-020-059-A ** ON A/C NOT FOR ALL

A. Removal of the Proximity Switch

Proximity Switches (6WN1, 6WN2) of the Aft Emergency Exits ** ON A/C NOT FOR ALL

(1) Disconnect the electrical connector (1) from the proximity switch (2).
(2) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(3) Remove and discard the lockwire.
(4) Remove the nut (4) and the washer (3).
(5) Remove the proximity switch (2).

[Rev.10 from 2021] 2026.04.02 06:28:35 UTC