Installation of the Seal of the Forward Avionics-Compartment Door

TASK 52-41-11-400-003-A
Installation of the Seal of the Forward Avionics-Compartment Door

WARNING: PUT THE SAFETY DEVICES AND THE WARNING NOTICES IN POSITION BEFORE YOU START A TASK ON OR NEAR:

THE FLIGHT CONTROLS
THE FLIGHT CONTROL SURFACES
THE LANDING GEAR AND THE RELATED DOORS
COMPONENTS THAT MOVE.

MOVEMENT OF COMPONENTS CAN KILL OR CAUSE INJURY TO PERSONS AND/OR CAN CAUSE DAMAGE TO THE EQUIPMENT.

WARNING: MAKE SURE THAT THE GROUND SAFETY-LOCKS ARE IN POSITION ON THE LANDING GEAR. THIS WILL PREVENT UNWANTED MOVEMENT OF THE LANDING GEAR, AND THUS POSSIBLE INJURY TO PERSONS AND DAMAGE TO THE AIRCRAFT AND/OR EQUIPMENT.

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
811

C. Referenced Information

REFERENCE	DESIGNATION
TASK 52-41-11-000-001-A	Removal of the Avionics-Compartment Forward Door
TASK 52-41-11-400-001-A	Installation of the Avionics-Compartment Forward Door
Seal of the Forward Avionics-Compartment Door

3. Job Set-up
Subtask 52-41-11-860-053-A

A. Aircraft Maintenance Configuration
(1) Make sure that an ACCESS PLATFORM 2M (6 FT) - ADJUSTABLE is in position at zone 120.
(2) Make sure that the forward avionics-compartment door 811 is removed (Ref. AMM TASK 52-41-11-000-001).
(3) Make sure that the parts retained from the removed component are clean and in the correct condition.

4. Procedure
Subtask 52-41-11-420-053-A

A. Installation of the Seal

Seal of the Forward Avionics-Compartment Door

(1) Put the seal (2) in position around the door (1).
(2) Put the seal-retainers (3) in position. Make sure that the groove of the seal (2) is between the seal-retainers (3) and the door (1).

NOTE: Refer to the marks made during the removal procedure to install the seal-retainers (3) in the correct position.

(3) Install the 24 washers (5) and the 24 screws (4).

NOTE: Do not fully tighten them at this time.

(4) Do a visual check of the seal (2) position.
(5) Slowly tighten the screws (4). Make sure that the pressure of the seal-retainers (3) stays regular.

5. Close-up
Subtask 52-41-11-410-054-A

A. Close Access
(1) Install the forward avionics-compartment door 811 (Ref. AMM TASK 52-41-11-400-001).
(2) Remove the ground support and maintenance equipment, the special and standard tools and all other items.
(3) Remove the access platform(s).

[Rev.10 from 2021] 2026.04.02 07:23:41 UTC