Removal of the Indicator Light

TASK 52-35-12-000-002-A
Removal of the Indicator Light

ZONE: 150
FIN: 8MJ

1. Reason for the Job
Self explanatory
2. Job Set-up Information
A. Fixtures, Tools, Test and Support Equipment

REFERENCE	QTY	DESIGNATION
No specific	AR	CAP - BLANKING
No specific	AR	SAFETY CLIP - CIRCUIT BREAKER
No specific	AR	SOLDERING IRON
98F52308330000	1	SPANNER-WRENCH

B. Work Zones and Access Panels

ZONE/ACCESS	ZONE DESCRIPTION
150	AFT CARGO COMPARTMENT FWD PRESS BULKHEAD TO AFT BULKHEAD OF AFT CARGO COMPARTMENT
154AR

C. Referenced Information

REFERENCE	DESIGNATION
TASK 52-30-00-860-001-A	Open the FWD or Aft Cargo-Compartment Door with the Yellow Electric Pump
TASK 06-41-53-00	FUSELAGE-DESCRIPTION AND OPERATION
Indicator Light 8MJ

3. Job Set-up
Subtask 52-35-12-865-053-A

A. Open, safety and tag this(these) circuit breaker(s):

PANEL	DESIGNATION	FIN	LOCATION
** ON A/C ALL
122VU	DOORS/CARGO	1MJ	T12

Subtask 52-35-12-010-051-B

B. Get Access
(1) Open access panel 154AR of the door control panel below the fuselage.
(2) To get access to service panel 2027VU, continue as follows:
(a) Open the aft cargo compartment-door (referred to as cargo door) and install the actuator safety locks (Ref. AMM TASK 52-30-00-860-001).
(b) Remove the applicable floor panel from the aft cargo compartment (Ref. AMM D/O 06-41-53-00).

4. Procedure
Subtask 52-35-12-020-051-A

A. Removal of the Indicator Light (8MJ)

Indicator Light 8MJ

(1) Remove the lamp assembly (1) and the rubber cap (2) from the lamp body (3).
(2) Remove the service panel (7) from the aft control panel as follows:
(a) Disconnect the connector (16) from the receptacle of the service panel (7).
(b) Put the CAP-BLANKING on each disconnected electrical connector and receptacle.
(c) Remove the screws (4) and the washers (5) from the inner side of the aft control panel.
(d) Remove the service panel (7) and the seal (6) from the aft control panel.
(3) Disassemble the service panel (7) as follows:
(a) Remove the screws (14) from the plate (13).
(b) Carefully remove the plate (13) and the seal (10) from the service panel (7).
(4) Remove the lamp body (3) from the plate (13) as follows:
(a) Remove the castle nut (15) and the lock washer (12) from the lamp body (3). If necessary, use the 98F52308330000 SPANNER-WRENCH.
(b) Remove the lamp body (3) from the plate (13).
(c) Remove the lock washer (12) and the castle nut (11) from the lamp body (3).
(d) Remove the heat-shrink tubing (8) from the wire harness (9) to get access to the soldering terminals of the lamp body (3).
(e) Make a mark on each wire/on the wire harness (9).
(f) Disconnect the wire harness (9) from the terminals of the lamp body (3) with the SOLDERING IRON.

[Rev.10 from 2021] 2026.04.02 06:28:09 UTC